(¥500) £499.91 exc vat
(¥600) £599.89 inc vat
(¥500) £499.91 exc vat
(¥600) £599.89 inc vat
Recommended usage 1 x HS2 to fit one mini.
This tool/gadget allows you to balance both air intakes on either twin SU or twin choke carbs so they flow exactly the same to give better performance and economy.
Carb repair kit less spindle and dbutterfly for single HS2 1.25"carbs-includes float needle valve and jet.
Special rubber hose 1/4" bore for use on petrol lines, this is in black and not armour plated outside but does have internal reinforcing. Supplied as pre cut 1m length with 2 clips and is safe to use with modern fuels with higher ethanol content. SAE...
This is the original type of needle valve that governs the plastic fuel float in your SU carb.
An alternative better upgraded version is available as CA90.
This kit for the HS2 type carb includes the fixed needle type bearing jet(sleeve)the adjusting nut,spring and locknut where you adjust your carbs.
.Quantity required for single carb-1 set or for twin carbs 2 sets required
Our heavy duty throttle cable is superior in many ways.
A nylon interior ensures smooth operation. The outer cable is 32mm longer and inner is 95mm longer than the standard one.
Cable to carb bolt is ACC5062.
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.
Orang...
Correct and original thickness oil for SU carb dashpots.
Complete with screw the choke trunnion is used on nearly all SU carb linkages.
See ACC5062 for carb cable link trunnion also.
Manifold to carb gasket for HS2 single and twin carbs, usually 3 per carb required.
Used in petrol fuel lines to take 1/4" petrol hoses it is used mainly on twin carb set ups for petrol being diverted to the 2 carbs.
This throttle return spring fitted every HS2/4 single SU carb and also on the twins as fitted by the factory. Twin carbs used AEC2075 for choke return. Total length 90mm.
Pin to hold the accelerator cable which locates in the carb bracket lever. Supplied as originally fitted with washers, nut and split pin plus a proper machined hole for the cable unlike many others on the market- which come either bare or with wrong ...