($153.60) £153.60 exc vat
($184.32) £184.32 inc vat
In stock
ALERNATOR original number 5L693
Complete with rear loom
($153.60) £153.60 exc vat
($184.32) £184.32 inc vat
In stockRecommended usage 1 x 5L829 to fit one mini.
Front loom only for Canadian spec mk4 cars.
You should always use this kit for fitting any auxiliary spot or fog lamps.
Kit contains wiring and safety relay-cheaper than a burnt out engine compartment.
Please note, SPI and MPI cars have this facility built as standard safety ...
The only battery cable to run the full length of the Mini, this has a positive type terminal that clamps arond the post rather than the helmet or cap type on much earlier cars. Some cars had slightly shorter cables than this but measure your old cabl...
Complete braided wiring loom for Cooper S MK1 with dynamo and oil filter light switch--as very few of these warning lights still work this loom is also supplied for cars without oil filter waring light and ignore extra wires.
For alternator...
Genuine Mini Spares L/H lamp with white lenses. This type of lamp was fitted from 1976 on as standard equipment with a built in reverse lamp.
Supplied with gaskets and correct coloured bulbs this has the more fashionable/retro white upper ...
Genuine Mini Spares R/H genuine lamp with white lens. This type of lamp was fitted from 1976 on as standard equipment with a built in reverse lamp. Supplied with gaskets and correct coloured bulbs this has the more fashionable/retro white upper lens...
Courtesy switch for MPI minis from 1996 when the wiring was changed from bullet type to spade connection. This is the switch that fitted into the A post to turn the interior light on and off, the earlier switch is no longer available so if you have a...
Four LA1009 halogen black bodied driving lamps approximately 170mm wide by 58m deep with 4-XBU10046 stainless steel fitting brackets.
Original manufacturer LESS THE GEAR 608092A this same wiper motor has been fitted since the late Mk2 version 1968/9 and is still used on the latest twin points but is wired up to give 2 speed and intermittent wipe.
The gear is ...
The headlamp bucket is isolated from the body with these rubber seals/gaskets.
Chrome plastic D shape type lamp fitted to many cars in the 1960s, the mini usually had two of these in black on the rear number plate of MK1/2 minis/vans and estates.
A metal version is available as BHA4153 and 83H335<...
BLACK HT SPARK PLUG LEADS TO FIT 23/25D DISTRIBUTOR WITH SIDE ENTRY CAP (GDC102).
7mm lead set
Best quality available-there are so many unreliable imports we have gone to Intermotor one of the original suppliers since the demise of original Lucas.
The activation of the starter motor starts with the key (or push button in the early car...
5 watt 12 volt festoon type bulb. For rear number plate light (PRC1230A) & interior lamp.Sold individually
Rocker light switch with blade connectors on the back. FITS MK3.
This is the Non Genuine twin filament front side and indicator lamp with a clear plain plastic lens glass that was usually fitted on USA or export models. UK cars had just an amber single filament indicator with amber lens. These are complete assembl...
Rocker switch for Mk2 & Mk3 two-speed wiper motor. Blade connectors.
This part often fails and if the conection points look dodgy replace the socket 520161 which also has a small loom.
BEZEL for mk2 on switch panel.
this item is satin finished, though can be polished by customer if required
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.