Exhaust mounting kit includes the 2 hanging brackets and 2 rubber mountings, new improved cast manifold clamp and fixing nut/bolts for installing an original standard 850/998cc saloon exhaust. To mount an RC40 exhaust system see RC40FK.

Exhaust manifold to downpipe clamp. For 32mm o/d pipe size.

The key to eliminating exhaust leaks at the manifold flange is the clamp. These cast clamps are the best style to use. A real piece of kit to use eradicating a multitude of likely p...

This sleeve will allow an 1"3/4 rear box to fit a standard bore front pipe of a 998cc mini. The large end fits into the RC40 and the smaller end accepts the 1.25" diameter as standard 850/998 exhaust pipe bore

Original exhaust bracket for rod change gearbox but later on Rover reverted back to GEX7526 which seemed a bit of a backward cost cutting exercise.

Middle exhaust mounting, bolts on to the front of the rear subframe and is the central or first of the rubber mountings. see GEX7081POLY for Poly type or if you are fed up with breakages see C-19G3257.The original Genuine pa...

Twin Down pipe clamp for Carb Coopers 1990 on wards, and Metro's.

Also used as a single clamp on manifold for cars fitted with HIF38 carb cars from 1991 on.

The center exhaust hanger takes a lot of abuse during hard acceleration or if you're low enough to bottom out on bumps. This mount has a through metal bolt to keep it intact.

The very rear bobbin type mounting rubber on every mini made until the introduction of a rubber hanger strap in 1992. When the RC40 or similar systems are fitted, 2 will be required.

See C-19G3258 for larger upgrade...

This is the hanger on the rear of the rear subframe for all Coopers and cars with an RC40 exhaust system. The u bolt to fix this to the exhaust is GEX9007.

All the parts to hang RC40 exhausts systems are available i...