£236.02 exc vat
£283.22 inc vat
In stock
For alternator type see 5L692
For PVC dynamo type see 5L832
Complete with rear loom
£236.02 exc vat
£283.22 inc vat
In stockRecommended usage 1 x 5L691 to fit one mini.
In pvc tape covering as original for dynamo type Cooper S MK2 cars, 3 wires to wiper motor. Complete with rear loom.
All Minis require an earth strap from the engine to the body and from 1959-1996
they fitted from the gearbox to the subframe. When they introduced the twin point in 1996 it was moved to the upper engine stabiliser arm. About 13"LONG.
Universal post type battery earth strap with clamp type fitting and correct length for most alternatives of batteries fitted.
The battery cover made of a special cardboard as fitted to all minis to protect
the battery terminals from metal objects. See also the 14A7666 retaining strap.
A plastic lamp spade connection with sidelight bulb aperture for use on sealed beam units only. Uses a GLB501 capless bulb. The mini clubman used sealed beams but had independant side lamps and therefore had an equivalent unit less the s...
The only battery cable to run the full length of the Mini, this has a positive type terminal that clamps arond the post rather than the helmet or cap type on much earlier cars. Some cars had slightly shorter cables than this but measure your old cabl...
Braided BLACK cotton covering with yellow flashes,this complete loom fits MK2 Cooper S with alternator and 3 wires to wiper - pre wiper plug type.
Complete with rear loom.
Braided rear part loom ONLY for MK1 Minis without a rear heated screen.
Lots of things have been written about performance plug ignition wires but regardless of what you believe we all know that good wires are a must. This special competiton wires set from the Lucas factory has 8mm wire and the highest performance, no br...
Wiper Swithch MK1/2/EARLY MK3 blade type switch for using to convert to 2 speed wipers when current 2 speed wiper motor is used.
For those very early 25D type distributors.Mini Spares version for modern fuels as fitted to our distributor range with slide on vaccum hose inlet pipe-not the very first screw in type
Plastic holder for the later flasher unit GFU2218. Needs to be mounted to the bulkhead prior to fitting the flasher unit to the holder
INDICATOR LAMP WITH ORANGE LENS AND LED BULBS. Sold singly, 2 required per car
Stainless steel screw kit for all mk2/3 lens to lamp body. Comes as a car set with six screws and six fibre washers.
Best on the market, sports coil-Not Lucas. A standard coil can only do so much, and when compression is raised (as in most high performance engines) or improper fuel mixtures occur something better is needed. This sports gold coil with proven origina...
CSI-Ignition is a fully electronic ignition built in an original housing. You will have to remove the cap to see the difference! Neg earth only
After removing the cap you can select between 16 different curves by using
a screwdriver...
Single bullet connector used to join the front loom to the rear loom near the wiper motor.
Double bullet connector used to join the front loom to the rear loom enar the wiper motor.
These are the screws needed to fix the condenser, points and base plate to 23/25D distributors. See 57H5135 for 45D type distributors.
The wiper motor drives a rack inside the metal tube that fits beneath the dash of the Mini. The rack is very well protected inside the case, but the problem is that the tube is often bent and/or rusted. Our special kit supplies all 3 pieces and the s...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.