£14.50 exc vat
£17.40 inc vat
Out of stock
stamped 2A3358 and MOWOG on back
£14.50 exc vat
£17.40 inc vat
Out of stock
Competition crownwheel bolt for use with our LSD crownwheels, these are CNC machined from EN24T with a reduced head height for more gearbox clearance.
New Minispares Evolution straight cut crownwheel and pinion set 3.875. The crownwheel in these kits has a 20% wider gear than previously supplied, and a pinion made from Aero quality steel making it 20% tougher.16x62 teeth count
Always Check...
Single roller bearing that only fits 3 synchro gearboxes to hold the 1st motion shaft-sporadic stocks only of these bearings as they went obsolete in 2008. These are genuine NSK bearings
Remote type gearboxes had four UNC bolts holding the long alloy housing to the differential case. These are the shorter two, 3/8"unc 1"long. The longer two are ZCS628.
Also the bolt to hold the starter motor.
Also the bolt for the [...
Mini Spares own Evolution limited slip diff with over 10 years success
No serious competitor would use a Mini on a race track or autocross course without a limited slip differential should the rules allow it. This original Mini Spares Ev...
Hardened flat washer to be used with flange type LSD Hardy Spicer C-BTA1262 outputs.
Two of these long UNC bolts are required to hold the alloy remote control to the gearbox diff housing on Remote type gearboxes. The two short UNC bolts are GFK5240.
Anybody proud enough to still be driving around with their 3 syncro gearbox needs all the encouragement they can get! We are pleased to be able to still provide these to keep the car alive and feeling like new. The shift forks are made of a brass t...
This is the bracket that the remote control gear lever rubber mounting 21A956 bolts to and bolts to the floor tunnel.
The bronze bush in the differential housing that the gear change selector rod sits through which should be lightly greased.
Fitted all manual minis up until the introduction of Rod change gearboxes. This is the 3rd/4th fork for 3 synchro 1st/2nd fork and 22G889MS for 4 synchro 1st/2nd fork on Pre Rod types.
see 2A3492 for the special bolt
for the inspection plate on the front cover of the transmission where the speed cable goes to -it has 2 bolt holes cut out
Detent spring in the gearbox on the rod type gearboxes. Some owners have fitted the 22G2083 slightly smaller detent spring which can work but the reverse swicth GAE131 will not function.
Mini Copper Sump Drain Plug Washer, also will fit the oil transfer pipe block fitting on Pre 1992 Blocks.
Fitted in the gearbox remote control this half moon seal butted up against the gearbox remote housing. The big large plug the other end is 22A271.
Front main (half moon) black seal for all transverse engines. This is the flexible item as fitted originally after replacing the early red type that leaked.
See [link]CAM6548{/link] for the rigid seal designed by Rover for all their warran...
Special circlip to hold the hardy spicer output shaft into the LSD units
such as evolution and Salisbury.
Follow your speedo cable to the gearbox and it screws onto an alloy housing bolted to the gearbox. This is the gasket between the housing and the gearbox.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.