£5.45 exc vat
£6.54 inc vat
Out of stock
£5.45 exc vat
£6.54 inc vat
Out of stock
Always check these grease nipples on your front hubs are working as they are very important. These two swivel pin grease nipples are the same, upper and lower. Also used on the rear radius arms. Sold individually.
these are top quality greas...
Complete rebuild kit for rear radius arm as sold by us since 2005.
Beware of cheap imports that are available in the market as they do not have correct heat treatment where required and have no longevity.
Kit Includes: shaft, beari...
Genuine Mini Spares product ideal for road use for maximum performance, where other examples available tail off as they get worked and heat up.
Hilos will be required to enable fitment as they are taller but FAM3968EVO are a str...
Exchange arms for dry suspension, later type with a bush and bearing.
We will not accept very early 2 bronze bush type from the 1959/60 era or any arms if they are bent or damaged. If you've ever had to rebuild a Mini trailing arm you know w...
Complete rebuild kit for rear radius arm as sold by us since 2005.
Beware of cheap imports that are available in the market as they do not have correct heat treatment where required and have no longevity.
Kit Includes: shaft, beari...
Mini Spares product from own original tooling since 1989.This small sheet metal panel mounts below the horizontal seam, covering the pivot pin of the R/H rear radius/trailing arm.
This shroud uses 14A7091 rubber plug not suppl...
The weathered and cracked rubber you see is not actually the hydro displacer bag, but rather this rubber boot to protect it. Sold singly 1 required per displacer.
See-Mini Spares own UK made GSV1118EVO first for a correct upgraded version with an improved poly gaiter and original genuine cup on EN24T pin with correct shape ball for a great value item.
Mini Spares own part will out surviv...
These are the metal rods required to fit your Hilo kit to the rear of a mini.
special double coil spring washer which fits on the rear hanbrake quadrant on Hydrolastic cars only.Known as a thackery washer
Fits top and bottom of the front damper and the lower rear damper to keep the bush from moving in the damper (shock absorber) eye sockets. 3/8"hole.
1.4mm thick by 24.6mm wide.
The rear handbrake sector fitted to the rear radius arm on hydrolastic cars only
which was different from dry suspension types. Can use PFR109 clip to secure. 2 required per car but sold singly.
Mini Spares product from own original tooling since 1989.
This small sheet metal panel mounts below the horizontal seam, covering the pivot pin of the rear L/H radius arm. Was unavailable for many years.
This shroud uses [link]14A7...
Replacement rubber cone produced from original factory tooling to the original specification, complying to the original Rover/BMC drawing and manufactured in the UK and easily identifiable by having the original patent number "763432" moulded in to t...
Mini Spares genuine product from original supplier with the correct shape and material nylon cup, for any knuckle joints GSV1118EVO and GSV1264 and aftermarket GSV1118MS.
As of 2019 we have found Rover ...
The bleed valve for fitting on the hydrolastic suspension where you pump it up.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.