Used on some special and racers without charging system this belt is 737 mm long

For high performance engines an efficient crank damper is a necessity to reduce failure. The standard damper commonly used is barely adequate for the standard engine. Mini Spares has reproduced the original "S" damper and pulley-far superior to the s...

This thinner crankshaft oil seal was used on the later belt drive kits with a plastic cover and larger diameter crank gear

Lower rubber seal for belt-drive timing gear.

Timing belt camshaft drive systems have been around for a number of years, in fact for a lot longer than the life expectancy of the belts. If you have a belt drive conversion you should have one of these replacement belts. If you want to keep things ...

Countersunk screw for holding the front palte to the crankshaft bearing cap on cars fitted with duplex gears to give the clearance required. 2 required per car.

ESPECIALLY FOR MINIS

This 20-50w semi synthetic oil is produced especially for minis where it needs to lubricate both engine and gearbox parts giving the neccessary coating and protection. Semi synthetic has a long life to 100c with maximum ...

The oil pressure relief valve consists of an aluminum plunger with a heavy spring behind it. Access is through the 15/16" domed cap nut beside the dizzy. Once this nut is removed the spring will be visible. The plunger is beneath the spring and will ...

A series mini engine crank pulley bolts have been known to come loose, caused by pulley damper vibration on competition engines. This is a high tensile longer extended thread cap head bolt with thick washer to rectify this problem and also allow furt...

Genuine Mini Spares Klinger timing chain gasket for any BMC A series engine with 10 gasket holes, fitted until the introduction of the A plus type which had a bulge in its side where the tensioner was fitted which had 11 holes.

The klinger m...