DASHBOARD 3+3 EXTRA CLOCK BLACK LHD
DASH012

£185.17 exc vat

£222.20 inc vat

Out of stockOut of stock
Black dashboard for cars with 3 clock speedo cluster in front of the driver on left hand drive cars.

£185.17 exc vat

£222.20 inc vat

Out of stockOut of stock

Alternative products

For cars with 3 clock speedo cluster in front of the driver on left hand drive cars this has 3 extra gauge holes cut out.

People also bought products

For cars with 3 clock speedo cluster in front of the driver on left hand drive cars this has 3 extra gauge holes cut out.

Lovely Burr walnut dash for left hand drive cars with 3 clocks in front of driver.

Fresh air vent for the dash, these bolt to the bulkhead and the eyeball socket vents fit into them. These used to be handed but this vent has both hole patterns so will fit both sides. This replaces 37H7035, 37H7036, JJB101000 and JJB101010. Sold ind...

Special clip for the lower brightwork moulding 14A8009 for finishing off the lower dash, crash pad rail, or on earlier cars the painted metal surface of the panel which holds the switch panel section.

The moulding 14A80...

door cappings in carbon fibre to compliment carbon fibre finished dash

Works Dash for LHD cars.

The later type more common dashes as used on the classic works Monte Minis and rally cars from ST Abingdon.


In crackle black finish.


Attaches to top and bottom parcel shelf rails either side...

2 outer rings and 2 inner knobs which have to be stuck on.

Bezel for 24A2702 oval 3-gauge pod. This is the brightwork trim on the front of the plastic pod, it is held on with up to 14 whisker clips 14A9796. The clip to join the ends together for neatness is 24A472
<...

The black plastic pod which mounts the speedo and two gauges in the original central position. In the 1970's and 1980's a great number of Mini owners caught the customizing bug and a lot of Minis had custom dashboards installed. Now we're going the o...

The black vinyl covering that lays on your lower dash shelf. For cars after 1970 where the facia panel is not a full metal panel you must fit (link)DT3076(/link)

ALSO SUITABLE FOR EARLY MK3 CARS THAT RETAINED THE DASH MOUNTED STARTER SWITCH AND TOGGLE SWITCHES CARRIED OVER FROM THE MK2 CARS.THE CHROME TRIM FOR THIS IS ALA6640

Fitted for safety regulations to all MK2 minis from 1967-80 except Sweden and Canada to 1975 (not any MKI or van and pick up). Later commercial type minis did have it fitted with 3 clock speedo pod. This is a hard foam pad at the lower edge of the pa...

Dash liners without air vents for either side of the speedo on deluxe versions such as the Cooper S with centre speedo and two gauges which are black vinyl covered as opposed to the painted type. Not for the single centre clock only.

see [li...

Dash liner black painted cardboard without airvents and oval hole for deluxe speedo cluster.Not for single speedo only cluster.For Vinyl leathercloth type see ALE2927

Black painted liners for deluxe cars with air vents and central speedo and 2 gauges.

Ashtray that sits in the upper padded dash on all vehicles with 2/3 clocks positioned in front of driver. Early cars had flat plastic tray face whereas later cars had crinkly type face which is the only type available- They all fit the same.

Late type swith carrier with 4 square holes plus heater and choke cable holes-uses the ratchet type choke cable with D shape fitting--earlier cars used round hole for pull and push chooke cableCZH3591

Our lightweight underfelt kit is the perfect companion when fitting a new headlining. Made from lightweight felt and cut to size, this fits into the cavity of the roof before fitting your new headlining and provides increased sound insulation and pro...

Mk1 style alloy gear knob. Will suit any Mini standatd gear lever thread.

3 point automatic rear seat belt. These seat belts do not use the standard C post nor the MPI fixing in the rear pocket. They require the fitting of the real on to the parcel shelf. These seat belts will work for all minis up to 1996


<...