£21.77 exc vat
£26.12 inc vat
In stock
£21.77 exc vat
£26.12 inc vat
In stockRecommended usage 1 x DRC3017 to fit one mini.
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.
This is...
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.
Orange ...
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.
Orang...
Paper gasket for either side of the spacer on all mechanical fuel pumps fitted on the rear of engines. The spacer with gaskets fitted is available as GUG705603GM.
Pumping 40 gallons per hour this is ideal for big bore/stroked engines with twin choke or split carbs over 45mm choke size and will require 5/16" fuel lines
Genuine Mini Spares product. The seal that goes on the neck of petrol tanks as protection against water intrusion and to also to make the hole look neater, so replace them when they crack or shrink through heat. This is the original fatter type as us...
Original 7/16" spring type hose clip as used on later cars (approx 1990 on) for some radiator hoses and fuel lines.
5/16" bore petrol hose for injection cars sold in metre lengths.
Resilient to heat,weather and suitable for ethanol in modern day fuels.100psi max.R9 spec.
Electronic Ignition distributor, fitted as standard to all 1300 Carb Cooper models. Also Metro 1275cc engine.
Replacement service items for this are:
Cap GDC156
Rotor arm GRA2143
Should be used with GC...
Fits the end of the wiper motor to hold the outer casing to protect the rack cable which drives the wheel boxes. Not supplied with new motors.
Vent pipe from petrol tank
late cars were only 765mm or 31" approx, but Mk1 cars were 54"
complete rebuild kit for Turbo type HIF44 carbs including needle valve and throttle spindle plus disc.With damper clamp ring as fitted to turbo only
Rocker switch for all models with front fog lights fitted as standard. Please note the lens colour is now green. 6 pins on the back for plastic loom connector.
Original equipment on the twin point cars this is the roof mounting base and the ariel comes seperate-See XUJ100070
Carb repair kit less spindle and butterfly for single HS4 carbs-includes float needle valve and jet. Full repair kit with spindle etc is CRK227-----for waxstat type see CRK121, This kit is suitable for pre Waxstat (pre 74) Minis only
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.