£23.92 exc vat
£28.70 inc vat
Out of stock
Correct moulded shape with extra protection on right angled section to enable easy fitting
JHC10007 was the same hose but 4" longer to suit L/H/D
NOW OBSOLETE USE GRH905 HOSE SOLD PER METRE
£23.92 exc vat
£28.70 inc vat
Out of stock
Heater hoses and expansion tank hoses are mostly 5/8" from 1985 on so check the bore size as some were actually 1/2" hose with flared ends of 5/8" you will need to use a restrictor pipe MOC210.
Original 5/8" rover hoses were 1"(...
Heater to in line heater valve -this hose is 8" to short bend-long part is about 14.5" and the short bend is 2.25" long. 25"total length if using GRH905. £26.99 exc vat £32.39 inc vat
Used with BAU5043 heater and 5/8"hose pre1991. This hose fits
Once the old type alloy heater valve on the head was discontinued in 1990 for the plastic free floating inline type this take off union was fitted in its place on A series engine cars for use with the larger 5/8" hose. Uses 88G221 gasket...
Long lasting silicon by pass hose between cylinder head and water pump.
These are easy to cut and slide on easier than the old conventional rubber type.
It has been made this length to fit 1275cc engine,which used the longest hose.<...
Fitted from A plus on to increase engine running temperature. If your radiator has a sender unit in the bottom you may have an expansion tank and therefore the radiator will need a better sealing pressure cap which allows a small vacuumGRC20...
Special thin type clip for fitting the water by pass hose between the water pump and the cylinder head. Most ordinary jubilee clips will not fit the tight area where the hose fits. Also used on C-AHH8537 oil cooler hose.
This grommet is used on all top radiator to cylinder head brackets plus the bottom bracket on earlier two piece radiator cowlings.It replaced the CAM4414 flatter bush originally fitted to the top bracket from 1974 on one piece cowlings
Genuine water pump gasket, green one side and grey the other, grey side to the water pump.
1275cc engine top hose in Rubber with Kevlar reinforcement.
Kevlar is a high tech aramid fibre produced by Dupont co in USA.
It is longer lasting, stronger with less heat transfer and wear resistance.
Not only does this hos...
Lower Radiator Hose-See C-GRH1159 silicon hose also which is priced to sell.
The lower hose on the late model Mini is VERY different! You've got to have one of these when you need it!!! Typically found on all Minis 1990-1991 wi...
This is the bolt that goes through ARP1073 spacer on lower radiator mount on cars from 1974 with a one piece cowl. 5/16 bolt 3.2502 long with small amount of 1" thread at end.
Standard 27.5mm overall length. Very early vehicles had a much longer neck GRC101 AT 33.6mm high.
