£1.65 exc vat
£1.98 inc vat
In stock
£1.65 exc vat
£1.98 inc vat
In stockRecommended usage 1 x NAM9197 to fit one mini.
This gasket sits under the clutch master cylinder.
For brake master cylinders see 31G840.
Gasket used under the dual master cylinder brake master cylinder. For the earlier single line brake pipe system see 31G279.
Pre bent steel brake line from RH brake hose union to the LH brake hose.
Clamp plate to hold servo brake pipes. Two required. Fitted to Cooper S and early 1275 GT. 1963 TO 1974.
Non spacered die cast alloy brake drums. The alloy material has a finned design that dissipates heat quicker which in turn helps reduce brake fade. Sold as a pair of drums.
We are now able to offer the origianl style 1 piece moulded carpets as fitted to 1997-2000 cars, these come supplied with the underlay although it is available separately under part number CK907. You could fit this carpet to any rod change Mini with ...
Rubber gaiter to keep debris from entering the drum via the backplate handbrake lever SMN10005. Sold singly per backplate, 2 required per car.
Genuine AP Lockheed rubber boot
Set of 4 hoses, 2 front and 2 rear.
Braided brake and clutch hoses have a PTFE inner which helps to eliminate the spongy pedal feel under arduous conditions, and give greater efficiency. The outer braided stainless steel cover e...
Extra high boiling point (above 310°C) brake fluid exceeding the requirements of SAE J1703, SAE J1704 and FMVSS 116 DOT 4 for use in competition braking systems.
Application
Use for racing and high performance br...
Bleed nipple for all rear wheel cylinders and is 7mm spanner size. Nearly all
current wheel cylinders are using 7.8mm rather than 6.2mm(1/4")spanner size but same 1/4"unf thread. See 660510 spanner for this size bleed nipple.
Seal for between the brake servo and master cylinder, fits all late 1988 onwards vehicles where the master cylinder was mounted directly to the servo unit.
Set of 6 hoses, 4 front and 2 rear to fit the ERA turbo.
Braided brake and clutch hoses have a PTFE inner which helps to eliminate the spongy pedal feel under arduous conditions, and give greater efficiency. The outer braided st...
Replacement rubber grommet for the servo vacuum hose for the 1992 onwards brake servo (GSM119)
Mk1/2 in-line brake servo valve for 21A1293 servo. It is essential if you do not have the correct U shape section formed in the servo hose to stop petrol contaminating your servo. Not supplied in any kit it is an important part. If you ...
NICKEL copper easy bend brake pipe with 2 metric male unions. 22"long, for 1988 on master cylinder lower outlet to PDWA valve outlet nearest to wing-other pipe is HMK026-both for left or right hand drive.
These pipes are retail...
We now supply 2 easy bend copper nickel pipes with the correct unions for when converting to the later type GMC227 front to rear split master cylinder.
EBC Blue Stuff pads are the endurance-grade, longest lasting material. Blue Stuff pads have a slightly lower friction coefficient than their counterparts; Green Stuff, Yellow Stuff and Red Stuff, but delivers far longer life.
Blue ...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.