£8.54 exc vat
£10.25 inc vat
In stock
£8.54 exc vat
£10.25 inc vat
In stockRecommended usage x RM5U to fit one mini.
Amal carburettor kit for the Arden 8-Port head. Complete with carbs, manifolds and linkage.
These cone springs will require Hilo adjustable suspension as they sit higher than the originals.Containg an anti fade property and shape which helps them going off during racing and giving hopefully a season of racing before replacement. A softer ro...
Uses 2 Soft standard rubbers on the insides and the 2 Mauve poly on the outside.
HARD OUTERS / SOFT INNERS - STOPS BRAKE WEAVING.
Don't be confused as this special shore hardness set up was proven after 2 years of testing and is per...
Mini Spares product UK made especially for use when geometry has been changed, such as fitting adjustable tie rods or lower arms, or on any cars with corrected castor angles.
Set of 4 bushes.
These metal sleeved bushes are specially...
Replacement spherical joint, these are known as the male type joints which are used on our lower arms or tie bars. Also known or referred to as rose joints as they were originally made and trade marked as such.
These spherical rod ends are also known as Rose joint which is a registered trade mark--we use either some of ouranti roll bar and linkage kits. this is the male type whith an (external thread)
Ultimate lower arm for road or race. (pair supplied)
One piece, forged, fully adjustable on the car lower arms (with knuckle for bushes) to allow adjustment for any camber setting required. Sold in pairs only. It is recommended that you fit ...
Original large boot to fit over and protect rod ends (rose joints). Sold individually.
Rear progressive bump stop kit for hydrolastic cars. Mounting brackets and rubbers. The rearward pitch under hard acceleration can be minimized by the fitting of progressive bump stop kits. This also improves the car's handling when fully loaded.
Adjustable anti-roll bar kit complete
The kit contains a 3/4" steel bar, mounted in alloy mounting blocks. Two collars welded to the bar restrict sideways movement of the bar. Fully spherical jointed with sliding alloy blocks to allow ra...
Replacement screws and nylon inserts for the Van, Estate and Pick up petrol tanks.
Used on Facet range of solid state and silver fuel pumps SS501/2/3 with 1/8" nptf thread size with 1/4" standard fuel line.
Gasket/seal for mounting the fuel pump to tank for SPI and MPI Mini's
Our heavy duty throttle cable is superior in many ways.
A nylon interior ensures smooth operation. The outer cable is 32mm longer and inner is 95mm longer than the standard one.
Cable to carb bolt is ACC5062.
Complete rebuild kit for rear radius arm as sold by us since 2005.
Beware of cheap imports that are available in the market as they do not have correct heat treatment where required and have no longevity.
Kit Includes: shaft, beari...
A very usefull tuning needle for single and twin carbs when camshaft change for carbs with floating needles.
Silver top competition fuel pump with 5-6 psi -30 gallons per hour,is ideal for high output engines especially using a twin choke carb such as weber/dellorto with choke sizes up to 45mm. Has 1/8"nptf threads for 1/4" fuel line
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.