£1.41 exc vat
£1.69 inc vat
In stock
£1.41 exc vat
£1.69 inc vat
In stockRecommended usage 1 x YJJ100040 to fit one mini.
Battery rod with loop for cars with larger battery 8.55mm long.
Also see 5L1158 shorter version at 6cm long for Pre 1990 cars.
This item for post 1990 cars is the looped battery fixing rod with longer thread that fits o...
Battery rod with open loop.
At 5.5cm long this is the open loop rod by the negative terminal which hooks into the battery box bracket. Also see YJJ100040 at 7.5cm lomg made ffor 1990 on cars with bigger battery.
Battery bar and fitting kit for all post 1990 cars whcih had the longer battery bolts.
Battery bar and fitting kit for all post 1990 cars whcih had the longer battery bolts.
Battery bar and fitting kit for all pre 1990 cars whcih had the shorter battery bolts.
Small battery cable retaining bracket bolted at the front of the engine for pre engaged manual cars approx 1985 onwards.
universal battery clamp replacement with securing bolts and marked N
Your battery box 5L877 should be held in place by this rubber strap.
Universal post type battery earth strap with clamp type fitting and correct length for most alternatives of batteries fitted.
Universal battery clamp replacement with securing bolts and marked P.
Also see YJH100010. 8.5cm Long for later cars this is the looped battery fixing rod for pre 1990 cars. This rod fits on the back bracket by the positive earth terminal with a nut and bolt.
Battery rod with open loop.
At 5.5cm long this is the open loop rod by the negative terminal which hooks into the battery box bracket. Also see YJJ100040 at 7.5cm lomg made ffor 1990 on cars with bigger battery.
Main wiring grommet that fits in the front parcel shelf. ID 12.5mm fits 35mm hole.
Dip switch lead for right hand drives cars, these are not included with new looms.
This will replace the orange lens fitted on the wing of all cars from 1986 on, fitted with an orange LED. If you need a new loom for this lamp see AFU3358. Sold singly. Does not require a resistor.
Genuine Bosch lambda sensor, fitted to both the twin and single point injection cars and fitted in the same exhaust manifold shared by both cars. Be warned the cheaper non branded sensors cause lots of issues hence we only sell the Bosch version.
Electronic ignition conversion. For points type distributors, fixed or sliding. Negative earth only. Also, available for earlier 23/25D on Negative earth (LU142) or earlier 23/25D with Positive earth (LU142AP12).
ONLY use GCL217 coil for bal...
Sports coil for ballast resistor type ignition.
Best internal parts tested and another intermotor top product.
Its not the name on the outside but whats on the inside which matters.
Original type coil bracket 12G29...
Pop rivet for fixing the headlamp bowl to the wing. Great for MS14 metal bowl but be careful if using on plastic bowls
Pre A Plus Electronic Ignition distributor with vac unit, modified to our specification in the UK to give best performance on any minis with std to 276 camshaft profile.
Brand New distributor complete with electronic conversion already fitt...
rear stop and tail lamp for early BMc cars with red plastic lens.
Also stocked is a white lens and single filament bulb equivalent for use as reverse light on kits cars and Mokes as CHM13REVERSE.
This is the hazard switch repair plug for post 1976 rocker switches, pins supplied so you can wire accordingly.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.