BATTERY BOLT FRONT WITH A HOOK END 6cm long (2.3/8...
5L1159

£2.60 exc vat

£3.12 inc vat

In stockIn stock
Battery rod with open loop.

At 5.5cm long this is the open loop rod by the negative terminal which hooks into the battery box bracket. Also see YJJ100040 at 7.5cm lomg made ffor 1990 on cars with bigger battery.

£2.60 exc vat

£3.12 inc vat

In stockIn stock

Recommended usage 1 x 5L1159 to fit one mini.
Battery Fixings, Control/Fuse Boxes & Flashers Un - Qty 1
Battery fittings, cables and main looms - Qty 1

Recommended products
Alternative products

They increased the length on this hook end bolt by 2cm in 1990. The shorter version @5.5cm is 5L1159 -this fits the front

Kit products

Battery bar and fitting kit for all pre 1990 cars whcih had the shorter battery bolts.

People also bought products

Battery bar and fitting kit for all post 1990 cars whcih had the longer battery bolts.

Bluetooth battery charge monitoring system. Compatible with smartphones running IOS, Android or Windows 10. Battery voltage can easily be checked via an app on your smartphone/tablet within bluetooth range.



Step 1

Download...

Small battery cable retaining bracket bolted at the front of the engine for pre engaged manual cars approx 1985 onwards.

universal battery clamp replacement with securing bolts and marked N

Universal post type battery earth strap with clamp type fitting and correct length for most alternatives of batteries fitted.

Universal battery clamp replacement with securing bolts and marked P.

They increased the length on this hook end bolt by 2cm in 1990. The shorter version @5.5cm is 5L1159 -this fits the front

Also see YJH100010. 8.5cm Long for later cars this is the looped battery fixing rod for pre 1990 cars. This rod fits on the back bracket by the positive earth terminal with a nut and bolt.

Currently the only battery bar available from rover to fit all saloons. There are however different length rods - see YJH100010/YJJ100040 and 5L1158/9.



Has hole centres at 9.75" and 11.5" for different bat...

Clip to retain the speedo cable to the bulkhead on pre 82 cars approx. This clip is also used to hold the loom to the inner wing on some cars.

Main wiring grommet that fits in the front parcel shelf. ID 12.5mm fits 35mm hole.

Interior lamp with a black on/off switch and pointed torpedo ends.

Also fitted many of the 1959on range of Austin A55/60 Cambridge, MG Magnette etc.

Also there was an alternative lamp with black switch and square ends 13H192 which w...

This is an ultra reliable universal hazard light module kit for any Mini that did not have hazard lights as standard (pre 76 cars).



A discreet but important safety upgrade for all classic vehicles.



Should you ne...

This will replace the orange lens fitted on the wing of all cars from 1986 on, fitted with an orange LED. If you need a new loom for this lamp see AFU3358. Sold singly. Does not require a resistor.

The smallest pre engaged starter motor available for the A series yet still producing 1.3KW of power! Ideal for race/tuned cars with high compression and cars that need more room for oil coolers etc. See GXE1004EVO for inertia.

Genuine Bosch lambda sensor, fitted to both the twin and single point injection cars and fitted in the same exhaust manifold shared by both cars. Be warned the cheaper non branded sensors cause lots of issues hence we only sell the Bosch version.

Electronic ignition conversion. For points type distributors, fixed or sliding. Negative earth only. Also, available for earlier 23/25D on Negative earth (LU142) or earlier 23/25D with Positive earth (LU142AP12).

ONLY use GCL217 coil for bal...

Sports coil for ballast resistor type ignition.

Best internal parts tested and another intermotor top product.

Its not the name on the outside but whats on the inside which matters.

Original type coil bracket 12G29...

Pop rivet for fixing the headlamp bowl to the wing. Great for MS14 metal bowl but be careful if using on plastic bowls