WIRING LOOM-BODY 1989 ON EXCEPT FUEL INJECTION ...
YMD10258

£50.35 exc vat

£60.42 inc vat

Special orderSpecial order
Rear body harness with speaker wires, known as thin wall PVC covered wire type in FROM 1989 and occassionly fitted or found on early cars wothout any problems.



All rear body looms are OBSOLETE from Rover but we can get them made up...

£50.35 exc vat

£60.42 inc vat

Special orderSpecial order

Recommended usage 1 x YMD10258 to fit one mini.
Body looms and harnesses - Qty 1

People also bought products

Rear body harness with speaker wires,known as thin wall PVC type type which replaced the thick wall type in 1989. AN166 is the thick wall early equivalent.

If your car has no speakers just disregard the extra wires. This loom ha...

Cooper cars with HIF44 carb from 1990-91 R/H/D with pre engaged starter,side repeater lamps on wings, 3 clock instruments--The Cooper LE(RSP) 1990 model has different loom listed as YMC11388 but this loom has been used by trade customers...

We sell about 20 of these per year and many are used on similar models to those indicated-Main and dash loom only--No side wing indicators-indicator stalk on right-alternator-rear lamps with reverse lights-steering lock-inertia starter-centre speedo ...

You should always use this kit for fitting any auxiliary spot or fog lamps.

Kit contains wiring and safety relay-cheaper than a burnt out engine compartment.

Please note, SPI and MPI cars have this facility built as standard safety ...

This is the wiring short conversion loom that fits to the old central speedo and is used by people modifying from 2 or 3 clock dashes to single clock or just repairing damaged looms. With the correct bulb holders and spade fittings. Now uses 5x [link...

A plastic lamp spade connection with sidelight bulb aperture for use on sealed beam units only. Uses a GLB501 capless bulb. The mini clubman used sealed beams but had independant side lamps and therefore had an equivalent unit less the s...

The only battery cable to run the full length of the Mini, this has a positive type terminal that clamps arond the post rather than the helmet or cap type on much earlier cars. Some cars had slightly shorter cables than this but measure your old cabl...

First of the thin wall looms, fits 998 cars October 1988> from chassis number 396449 on with a brake servo fitted and dim/dip relay on the headlamp flashers. All cars with side repeaters on the wings, 3 clock cluster, pre engaged starter. L/H/D cars ...

Braided BLACK cotton covering with yellow flashes,this complete loom fits MK2 Cooper S with alternator and 3 wires to wiper - pre wiper plug type.

Complete with rear loom.

Double bullet connector used to join the front loom to the rear loom enar the wiper motor.

Printed circuit board for 1989 to 1996 3 clock Nippon Seiko type Mini gauge clusters. These have been unavailable for many years but have now been remade exclusively for Minispares.

Main wiring loom less dim dip for mainly overseas cars. Fits all 1275 cars with HIF38 carb from 1991-1994. Ignore alarm wires on early cars.

Main and dash loom only.

One pair of S6007 halogen driving lamps 135mm wide by 35mm deep approximately plus a pair of XBU10046 stainless steel brackets. The MONTE3 kit is double these parts.

Genuine L/H lamp.Beware of cheaper inferior lamps for sale.

Fitted from 1976 on as standard equipment this was the Lucas style lamp with the built in reverse lamp.Supplied with gaskets. Many people now change the upper lens to the more fash...

These are for Left had drive L/H/D. See S4698B for Right hand drive R/H/D.

Even at normal highway speeds it is common to "outdrive" conventional headlamps. These halogen headlamps have very bright 55/60 watt bulbs. Their special...

Genuine R/H lamp. Beware of cheaper inferior lamps for sale.Fitted from 1976 on as standard equipment this was the Lucas style lamp with the built in reverse lamp. Supplied with gaskets. Many people now change the upper lens to the more fashionable w...

Two of these plastic lens that hold festoon bulbs (GLB239) are mounted in the metal cast number plate housing (13H6900) on all MK3 bootlids from 1970on. Sold individually with bulb LESS FIXING SCREWS.

See PMZ206 for screw replac...

White lens kit 1988 on. If your front indicator lens is held on by screws then this is the kit for your car with the side wing repeater lens also and correct orange bulbs.

If your front lens is held on by the chrome retaining ring as per all...

Black wiper arm for L/H/D with a hook type fitting introduced in 1990 --This uses an 11" blade GWB911 made by Bosch which is the best blade we have found. 2 per car required and sold singly. Will fit any cars from 1970 on

with ...

This later type oblong fuse box cover was fitted to the box that held 4 fuses as opposed to two and was fitted from 1976-1996.

Complete fuse box less fuses is RTC440A.