£50.35 exc vat
£60.42 inc vat
In stock
If your car has no speakers just disregard the extra wires. This loom has bullet terminals for the roof lamp but Rover added wires with spade terminals to fit the interior lamp.
All rear body looms are OBSOLETE from Rover but we can get them made up from samples or the following definitions. From 1985 all cars had rear lamps with reverse lamps and one fog lamp fitted either on right or left---all had interior light in the headlining, rear heated screen, petrol tank gauge---
Changes were--washer bottle moved from engine bay to boot 1991, Fuel injected cars need extra wires to fuel tank for pump--speaker under rear parcel shelf replaced by speakers on top of rear parcel shelf---alarm swith
£50.35 exc vat
£60.42 inc vat
In stockRecommended usage 1 x AN169 to fit one mini.
Rear body harness with speaker wires, known as thick wall type which was replaced by thin wall PVC covered wire type in 1989. AN169 is the thin wall equivalent and occassionly fitted or found on early cars wothout any problems.
...
Main wiring grommet that fits in the front parcel shelf. ID 12.5mm fits 35mm hole.
Rear body harness with speaker wires, known as thin wall PVC covered wire type in FROM 1989 and occassionly fitted or found on early cars wothout any problems.
All rear body looms are OBSOLETE from Rover but we can get them made up...
Auxilary wiring for genuine Rover spot and fog lamps needed when fitting genuine lamps to cars not originally fitted with auxilary lamps or for cars that have had the wiring damaged. This loom is supplied with complete lamps XBN10008 and...
Main wiring loom with dim dip. Fits all 1275 cars with HIF38 carb from 1991-1994. No alarm.
Main and dash loom only.
Cooper and Cooper LE not RSP version although could be used--electic fan wires
different
Main and dash loom only
Was HAM3066 main loom less the wing side repeaters but superseded by Rover to this loom with side repeaters on wing,although the manufacturer of these looms always added them to HAM3066 anyway -Inertia starter, Ballast coil, Instrument cluster in fro...
Cooper cars with HIF44 carb from 1990-91 R/H/D with pre engaged starter,side repeater lamps on wings, 3 clock instruments--The Cooper LE(RSP) 1990 model has different loom listed as YMC11388 but this loom has been used by trade customers...
We sell about 20 of these per year and many are used on similar models to those indicated-Main and dash loom only--No side wing indicators-indicator stalk on right-alternator-rear lamps with reverse lights-steering lock-inertia starter-centre speedo ...
You should always use this kit for fitting any auxiliary spot or fog lamps.
Kit contains wiring and safety relay-cheaper than a burnt out engine compartment.
Please note, SPI and MPI cars have this facility built as standard safety ...
Inertia starter -no side repeaters on wing -Instrument cluster in front of driver,either 3 clock with tacho or 2 clock cars but ignore wires from distributor for tacho and tacho wires.
On pre 1984 cars the wiring for the indicator...
All Minis require an earth strap from the engine to the body and from 1959-1996
they fitted from the gearbox to the subframe. When they introduced the twin point in 1996 it was moved to the upper engine stabiliser arm. About 13"LONG.
When replacing the 520160A parking switch the inner contact areas on the wiring loom are also worn or damaged so we produced this socket and small length of loom.
Universal post type battery earth strap with clamp type fitting and correct length for most alternatives of batteries fitted.
The battery cover made of a special cardboard as fitted to all minis to protect
the battery terminals from metal objects. See also the 14A7666 retaining strap.
This is the wiring short conversion loom that fits to the old central speedo and is used by people modifying from 2 or 3 clock dashes to single clock or just repairing damaged looms. With the correct bulb holders and spade fittings. Now uses 5x [link...
A plastic lamp spade connection with sidelight bulb aperture for use on sealed beam units only. Uses a GLB501 capless bulb. The mini clubman used sealed beams but had independant side lamps and therefore had an equivalent unit less the s...
The only battery cable to run the full length of the Mini, this has a positive type terminal that clamps arond the post rather than the helmet or cap type on much earlier cars. Some cars had slightly shorter cables than this but measure your old cabl...
First of the thin wall looms, fits 998 cars October 1988> from chassis number 396449 on with a brake servo fitted and dim/dip relay on the headlamp flashers. All cars with side repeaters on the wings, 3 clock cluster, pre engaged starter. L/H/D cars ...
Large grommet to fit 1"approx holes in bulkhead for items that need to be able to flex and move such as capillary tubes and oil pipes. 7/32" hole size.
The small hole will expand and is also used as wiring loom through bulkhead and battery c...
Fits the first cars with pre engaged starter,side repeaters on wings R/H/D
but no dim/dip relay(pink relay box) --if you have the pink relay use HAM4626--
HAM4626 can of course be used for this and ignore extra wires for dim dip.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.