£194.21 exc vat
£233.05 inc vat
In stock
On pre 1984 cars the wiring for the indicators and wash wipe might be slightly different as the switches were unified to European specification.
This loom should not have had side repeater lamps but the superseding loom had the facility which was not used--Rover number was HAM3066 but replaced by HAM3684 (Front loom only)
£194.21 exc vat
£233.05 inc vat
In stockRecommended usage 1 x AN128 to fit one mini.
A plastic lamp spade connection with sidelight bulb aperture for use on sealed beam units only. Uses a GLB501 capless bulb. The mini clubman used sealed beams but had independant side lamps and therefore had an equivalent unit less the s...
This rear loom is for cars with the reverse lamp in the rear lamps and spade type fittings from 1976 on---AN166 has a plug for the rear lamps which fits all new lamps which have a plug attached. With fog lamp.
Also Mini Clubman 1980-83.
Main wiring grommet that fits in the front parcel shelf. ID 12.5mm fits 35mm hole.
Was HAM3066 main loom less the wing side repeaters but superseded by Rover to this loom with side repeaters on wing,although the manufacturer of these looms always added them to HAM3066 anyway -Inertia starter, Ballast coil, Instrument cluster in fro...
Rear body harness with speaker wires,known as thin wall PVC type type which replaced the thick wall type in 1989. AN166 is the thick wall early equivalent.
If your car has no speakers just disregard the extra wires. This loom ha...
Rear body harness with speaker wires, known as thick wall type which was replaced by thin wall PVC covered wire type in 1989. AN169 is the thin wall equivalent and occassionly fitted or found on early cars wothout any problems.
...
You should always use this kit for fitting any auxiliary spot or fog lamps.
Kit contains wiring and safety relay-cheaper than a burnt out engine compartment.
Please note, SPI and MPI cars have this facility built as standard safety ...
All Minis require an earth strap from the engine to the body and from 1959-1996
they fitted from the gearbox to the subframe. When they introduced the twin point in 1996 it was moved to the upper engine stabiliser arm. About 13"LONG.
When replacing the 520160A parking switch the inner contact areas on the wiring loom are also worn or damaged so we produced this socket and small length of loom.
Universal post type battery earth strap with clamp type fitting and correct length for most alternatives of batteries fitted.
The battery cover made of a special cardboard as fitted to all minis to protect
the battery terminals from metal objects. See also the 14A7666 retaining strap.
This is the wiring short conversion loom that fits to the old central speedo and is used by people modifying from 2 or 3 clock dashes to single clock or just repairing damaged looms. With the correct bulb holders and spade fittings. Now uses 5x [link...
A plastic lamp spade connection with sidelight bulb aperture for use on sealed beam units only. Uses a GLB501 capless bulb. The mini clubman used sealed beams but had independant side lamps and therefore had an equivalent unit less the s...
The only battery cable to run the full length of the Mini, this has a positive type terminal that clamps arond the post rather than the helmet or cap type on much earlier cars. Some cars had slightly shorter cables than this but measure your old cabl...
Braided Wiring loom for MK1, floor starter with coil on dynamo and single speedo clock only. 1959-62 without temp gauge-to A2S7-197020- before temp gauge fitted.
The same loom in PVC is 5L322.
Same loom but for cars with temp gauge ...
Large grommet to fit 1"approx holes in bulkhead for items that need to be able to flex and move such as capillary tubes and oil pipes. 7/32" hole size.
The small hole will expand and is also used as wiring loom through bulkhead and battery c...
MAIN WIRING LOOM 1969 TO 1976 MK3 998 MINI AND COOPER S. ALTERATOR/PVC COVERED.
Complete with rear loom for electronic fuel pump.
Basic spec is: centre speedo oval dash, single stalk, toggle or mk3 rocker switches, inertia starter, ...
Fits the first cars with pre engaged starter,side repeaters on wings R/H/D
but no dim/dip relay(pink relay box) --if you have the pink relay use HAM4626--
HAM4626 can of course be used for this and ignore extra wires for dim dip.
This plug fits the hole in the inner wing where the wiring for the wing side repeater lamp goes through the body on cars after 1986.
Wiper motor fitting kit to fit all mk2 onwards wiper motors to the bulkhead.
Sports coil for ballast resistor type ignition.
Best internal parts tested and another intermotor top product.
Its not the name on the outside but whats on the inside which matters.
Original type coil bracket 12G29...
Negative earth only-45D electronic distributor with vac for 1275GT and any pre A Plus 1300cc engine including Sprite and Midget in line engines-
For best performance and tune we advise our electronic Evolution version C-27H7698<...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.