Showing 1 to 20 of 224

This door striker plate used to be sided on earlier models but fits either side now. CZH627 striker plate lock with a loop fits into this.

The genuine outer skin only for the R/H door of wind up window cars only. Without door mirror lug nuts (nutserts) but holes for the nutserts ADU2038. A door frame is also available as MSP020

All the last minis from 1996 were fitted with this internal safety bar behind the door skin.A door frame only is available as MSP021

The original door less hinges and safety bar are still avaialble as BMP306MS R/H a...

THIS IS THE SMALL DOOR HINGE GASKET ON THE A PANEL FOR SLIDING WINDOW TYPE DOORS.

R/H upper door hinge for MK3 on with internal door hinges and wind up window

also see kits MSSK017 and MSSK017B sets which are better value.

Flat replacement glass for the GAM215A/216A range of mirrors.

Screw that holds on the exterior plastic type mirrors to the door, plus the handbrake fairlead guides on the floor of the car - also holds air vent nozzles to dash. 3/16" unf 3/4" long including head - for plain washer see WA1090.

This earlier Mk1 door handle was thinner than the later MK2 type. This handle will also fit the passenger side as the non locking plain handle is obsolete.

A complete kit of 2 door and 1 boot handle with key barrels is available as [link]24A...

Genuine Mini Spares product.

This is the large gasket on the Mk3 wind up window door handle.

The small one is CZH1729 and the boot lid handle uses a seal CZH1747.

Right hand rear door for the clubman and mini estate as well as the van. These are from original tooling. The seal for the window is 14A7210 and if you want to grab the last of the rear window glass at sale prices see 14A7181

left hand rear door for clubman/mini/estates and vans from genuine tooling.

see also rear window seal 14A7210.

the rear door window glass are obsolete but we have a few left on clearance

2006-see 14A7181 for c...

Mk2 minis had a safety boss fitted between the end of the door handle and the door--this is the seal that fits hehind the boss (24A1834)

Clip to connect the door opening remote control rod plus the lock control mechanism fits on CZH640/1 and CZH616/7-- 2 per door. Also fits the wastegate on turbo models.

Money saving car set of genuine hinges for wind up window type doors from 1970 on.

Genuine door check strap for MK3 cars with wind up window doors.(use with retaining pin CLZ412 ). Beware! there are cheap copies on the market that are poor quality and when fitted to our cars did not function correctly.

Genuine Mini Spares product-Upper window channel for MK1/2 Minis. When replaced in conjunction with part # 24A88, the windows fit nice and tight, there are no rattles and the glass does not fly forward when you hit the brakes. Just like new.

The pin that goes into the door stay check arm on the door itself on all minis with wind up type windows from 1970 to 2000.

Genuine Mini Spares mouldings product as supplied to Rover.

R/H outer brightwork trim with the seal attached to stop water seeping down into the door frame, on all cars with wind up windows from about 1980 on, these are the later type with t...

Arrow next
1 2 3 4 5 ...