float lid screw for all HIF type SU carbs

HS2 float lid assy, also fits HS4.

A rare chance to do something the easy way and at the same time do it right. A new plastic float, pin, plus needle & seat assembly are already installed into a new float cover lid. Simply remov...

If fuel is overflowing the float bowl the needle valve is leaking. This may be caused by the float WZX13040(GSU200) being misadjusted, stuck or leaking OR the needle may be fouled with a bit of grit or worn and not sealing. This is an

altern...

Worn throttle spindles cause erratic performance from your carb and sometimes the housing gets worn--These are the bushes to repair worn carbs when replacing spindles for HS4 carbs. As a guideline 0.3125" internal diameter ream body to 9...

Fits single and twin HS2 carb dashpots but only single HS4 carbs(the twin HS$ use AUC8114) --See AUC8103HB for the original brass type fitted to early single HS2"

Seal for the HIF38/44 float lid chamber

Float grommet for the mini twin HS2/4 carbs---this 30 degree angle is for the L/H ( front) carb and is positioned to angle the float bowl--Used on both twin HS2/4 carbswhen using correct mini inlet manifolds- Midgets and MGB used different angles,u...

These screws fit all HS type carb butterflies to hold them on the throttle spindle

Complete with screw the choke trunnion is used on nearly all SU carb linkages.

See ACC5062 for carb cable link trunnion also.

The metal washer AUD2193 goes up against this seal on the jet where it enters the float bowl on all HS type carbs.