Mini Spares L/H copy of the original Rover 2 piece plastic roof moulding specially shaped for the corners and drain holes as fitted from 1980on in black. This is the left hand. For R/H see YGA1106
for a pair see YGA1105...
right hand rear
Genuine moulded wheel arch as fitted to the sports pack mini with 13" wheels has now been upgraded with a brass insert to take a stud ZUA000250. This item does not include the stud or the black rubber seam mouldi...
In 1993 the moulding between the wheel arches was changed from black plastic to rubber and was still used on twin point rubber arches. This is a Rover part but is different to what was originally fitted. Alternatively GZF105A and [link]G...
Original genuine rubber wheel arch to body seal with self adhesive backing. Factory fitted to all late Minis with either Sportspack arches or colour coded plastic arches.
Length 107cm. Sold individually.
Joining clip for genuine YGA1106/7 black roof trim mouldings as fitted from 1980 on. Athough black they require painting before fitting to cars.
pair of genuine factory rear mudflaps in hard wearing rubber with the cooper laurel embossed on them. Only designed to fit cars with plastic wheel arches as fitted standard from 1984 on
Innocenti - original Italian Mini Sumpguard. Very useful. Inexpensive protection for the fins on the gearbox. Made in sturdy, well fabricated steel/metal. Oil filter can be changed without removing sumpguard.
small header plate a few inches long on the front top windscreen rail for cabriolets only
These stainless steel peaks fit under the headlamp rim to give that old 60s style again.
For all mini pickups, vans, estates and MK1/2 Minis. Any early minis without a vent on the top of the tank can also use this cap.
A vented cap has been fitted to Minis during its history but must not be fitted to any Injection cars as they r...
Car set of fixings to hold on the Deluxe type overiders and corner bars, complete with sealing rubber to bumper and spacers.
If you have standard overiders see kit MSSK011.
From 1980 on minis had a D shape hole to take these push in windscreen washer jets.
This earlier Mk1 door handle was thinner than the later MK2 type. This handle will also fit the passenger side as the non locking plain handle is obsolete.
A complete kit of 2 door and 1 boot handle with key barrels is available as [link]24A...
This is the plastic filler seating to sit on the grille mouldings either end of MK2/3 on grilles. Fit these to protect your bodywork and make the surround look better seated.
Copy of the original heavy duty works lamp bar with all fittings but now in stainless steel for longevity.This type was used on LBL66D on the 1967 MONTE CARLO RALLY WITH THEIR NOW LEGAL LIGHTS Consists of a central support bracket and 2 end supports ...
These are the rubber plugs that sit in the windscreen scuttle panel where the extra holes are drilled by the factory to enable fitment of either left or right hand parking of the wiper arms. Plus use this rubber plug for some rear floor pans and batt...
OE chrome headlamp rim.
These chrome over ordinary steel headlamp rings are bagged or boxed & NOT including setscrew. Setscrew is RTC465. Using steel, they are however prone to rusting so Minispares have made a high quality chrome over brass...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.