($510.00) £510.00 exc vat
($612.00) £612.00 inc vat
Out of stock
picture is just to show what you get but bulge on centre tunnel for starter button appears to be on wrong side as this is a picture upside dowm--from bottom up
($510.00) £510.00 exc vat
($612.00) £612.00 inc vat
Out of stock
Non Genuine for the Pick-up and Van 1961-64 with a slat type fixed grille as a trademark for Mini commercial type vehicles originality.
Usually ordered for customers requirements as these are very rare models.
This panel has no b...
This Non genuine pattern panel has the holes for windscreen wipers and jets with barely an inch of pillar.
On cars from 1992/3 on check the original windscreen drain channel as the VIN numbers were stamped above the clutch master cylinder-wi...
Reproduction version os ASJ360070. For the twin point only as it changed shape to accommodate the front mounted radiator and different bonnet fittings.
Complete rear back panel section from roof to bumper valance with MK1 lamp and bootlid apertures but the backlight(rear window screen) aperture is only for models from 1967 to 2000. This panel is Not available genuine with the original MK1 size rear ...
For vehicles with external hinges and sliding type windows this is a full inner front wing with the wheel arch panel. The panel is what that the outer A panels for the hinges attach to.This is the left hand pane wing with radiator vent slats but not ...
For vehicles with external hinges and sliding type windows this is a full inner front wing with the wheel arch panel. The panel is what that the outer A panels for the hinges attach to. This is the right hand panel made by Heritage but not 100% perfe...
genuine rear lower back panel for MK2/3 on, which goes up as far as lower edge of backlight seal ridge
The crossmember holds the seat brackets and has the correct shape on the bottom to sit correctly on the floor of the rod change tunnel only. This is the complete section from inner sill one side to the other. Fits all square type rod change gearbox f...
Non Genuine metal battery box. always going rusty owing to the location of where it is fitted. Requires welding in place and preferably painted or a protective coat. Remember to check if the battery cover, strap and clips need changing. Popular afte...
the rear lower NON genuine corner section of the rear valance on vans.estates.travellers and pick ups L/H --See MS23 for centre section
rear subframe mounting stiffener L/H repair bracket with holes for subframe mounting and attaches to wheel arch Fits on ALA8623
THIS PANEL PROTECTS THE UNDERSIDE OF THE WINDSCREEN VALANCE UNDER THE FRONT WING SECTION also fitted on the inner wing panel 14A8346/7
This panel has mounting holes for later models facia crash panel. These holes will require blanking for true originality on earlier models without the facia pad
the rear lower non genuine corner section of the rear valance on vans.estates.travellers and pick ups R/H---See MS23 for centre section
lower section known as front panel for the clubman range only.his is the rubber monted subframe type as fitted from 1976 on-the earlier type which bolted direct to the subframe is CZH563
A non genuine panel made for repairing the corner of the windscreen panel which is prone to rust from water splashing up from underneath the front wheel arch.
Experience has shown its easier to fit the genuine panel HMP441001 al...
This lower rear valance is without any fog lamp or wiring holes and is also available as a genuine panel under part number 14A6940.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.