($1.14) £1.14 exc vat
($1.37) £1.37 inc vat
($1.14) £1.14 exc vat
($1.37) £1.37 inc vat
Recommended usage 2 x AUC1147 to fit one mini.
Linkage set for Converting from waxstat to standard type jet for one single carb .
Fuel or water T piece adaptor
used when upgrading fuel system size on specials from 1/4" to 5/16" or any other modifications
Jet bearing kit for HS4 carb for swinging needle type. This includes the adjusting nut, spring etc.
spindle and fixings only for the HS2 carb-the butterfly for this is WZX1320.
sorry folks but buying both kits you get double the gaskets
The little spring that sits at the end of a spring loaded carb needle on late HS and all HIF carbs where applicable.
Special rubber hose 1/4" bore for use on petrol lines, this is in black and not armour plated outside but does have internal reinforcing. Supplied as pre cut 1m length with 2 clips and is safe to use with modern fuels with higher ethanol content. SAE...
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.
Orange ...
This is the original type of needle valve that governs the plastic fuel float in your SU carb.
An alternative better upgraded version is available as CA90.
Our heavy duty throttle cable is superior in many ways.
A nylon interior ensures smooth operation. The outer cable is 32mm longer and inner is 95mm longer than the standard one.
Cable to carb bolt is ACC5062.
Clip on the heater valve for heater cables on vehicles from 1990 where the in line remote heater valve was used. It has also been used as a clip for HIF carbs to hold the cable but the one from Rover is 13H3472.
Correct and original thickness oil for SU carb dashpots.
The metal washer AUD2193 goes up against this seal on the jet where it enters the float bowl on all HS type carbs.
standard 850 single fixed carb needle sold per item