GROMMET FOR INNER SILL PANEL ON LATEST CARS
AYB10020

($1.30) £1.30 exc vat

($1.56) £1.56 inc vat

In stockIn stock
If you have square shaped hole 1" long by 13/16" on your inner sills this is the bung you require. Started appearing on cars from the 90s.



later cars use four in the inner sill, two in the door posts and two in the sill closing pan...

($1.30) £1.30 exc vat

($1.56) £1.56 inc vat

In stockIn stock

Recommended usage 8 x AYB10020 to fit one mini.

People also bought products

Complete car set of stainless steel screws for the piano hinge type opening rear quarter light windows.

Upper door moulding rivet for Cooper S door trim. For Mk1 usually 1 at front and 3 at back making 4 per side and on Mk2 there were 2 per end at bottom making 4 per side. This is the 10mm head rivet and not required on our own 14A9773/9774 trims that ...

High quality non genuine door check strap for MK3 cars with wind up window doors (use with retaining pin CLZ412). Beware there are cheap copies on the market that are poor quality and when fitted to our cars did not function correctly!

Stainless steel stud for original production factory fitted sports pack arches.

These use FN105047 nuts.

New genuine arches now have an upgraded threaded brass insert and now use a stud ZUA000250.

Mini Spares own MK3 Window drop rail kit includes 1 x ALA5746SS AND1 x ALA5747SS plus 2 x 24A948 seals for the drop rails to hold the glass, this kit will do one complete door only.

Large blanking grommet for the Clubman inner wings, 1.5".

Captive nut plate that sits behind the damper bracket on the inner wing/bulkhead to attach the damper brackets. 2 PER SIDE.

The gasket that sits behind the door stiker on all wind up window type minis

on the B post.

MK3 Door & boot handle fitting kit, including original type screws, star washers and gaskets.

Metal floor plug as per original with rubber seal.



For use in 1" hole.

Rear screen seal for mk1 cars which had the smaller rear window 1959-1967.

Complete fitting kit for the door check straps on all Minis fitted with external hinges.

The last type of rod change rib design floor made for the assembly line fits cars from 1997-2000. It has a large rib down the centre of the L/H side.

This floor produced from genuine tools has the crossmember fitted with the sill panels an...

Complete set of bolts to mount the front subframe on all post 76 single bolt subframes less the large tower bolts and towing eye, enough fixings are supplied for those who wish not to use a towing eye.

MK3 Mini door and rear quarter trim(4 piece kit) in Navy vinyl as per original Cooper S and Mini std design but for saloons from May 1973 on, when the rear quarter panel changed.Black or Navy will fit any wind up window type saloon with the liner to ...

Tank strap bracket welded to the rear of the boot floor which the single diagonal tank strap 21A2838 attaches to.

Angled spacer washer for Mk1/2 external door hinge cars for the upper hinge

Body side rear lower w/arch to rear section of bodyside repair L/H. 220mm tall.