($72.00) £72.00 exc vat
($86.40) £86.40 inc vat
In stock
($72.00) £72.00 exc vat
($86.40) £86.40 inc vat
In stockRecommended usage 1 x CDU3247 to fit one mini.
The classic Mini phone holder with USB replaces the existing ashtray in the padded dash rail.
Key Features:
Plate is made from powder coated 3mm steel
Spring loaded clamp, hold phones between 59mm to 106...
The Classic mini ashtray replacement digital clock has been designed to seamlessly replace the ashtray insert to ensure the integrity of your classic mini dashboard is maintained whilst introducing the modern technology of our digital clock and optio...
Small battery cable retaining bracket bolted at the front of the engine for pre engaged manual cars approx 1985 onwards.
Repair loom and plug for all post 1976 headlamp switches.See PM08 for headlamp switch with plug and correct wires colours for loom repair
Alloy dash for cars with 3 clock pod in front of driver + 3 auxilary gauges and L/H/D--these dashes have a knob on the glovebox.
Alloy dash for cars with 3 clock pod in front of driver and L/H/D--these dashes have a knob on the glovebox.
Black vinyl dash liners suitable for 2 and 3 clock clubman type dash with the offset clocks (Right Hand Drive).Vinyl will need cutting out for vent holes but the cardboard backing is pre cut
Printed circuit board for pre 1989 cars with Smith's type 3 clock gauge clusters. These have been unavailable for many years but have now been remade exclusively for Minispares.
Wooden 3 clock dashboard, with carbon fibre finish for LHD cars.
Quality HT lead set for twin point injection minis. For use with M4 type coil. Spiral bound wire giving instant greater resonance.
2 outer rings and 2 inner knobs which have to be stuck on.
Cable for solenoid to inertia starter on Pre-1985 minis or can be used as a long earth cable.
The black plastic pod which mounts the speedo and two gauges in the original central position. In the 1970's and 1980's a great number of Mini owners caught the customizing bug and a lot of Minis had custom dashboards installed. Now we're going the o...
This "Pigtail" wire is all that carries current through the distributor to the points.Fits 23 and 25d type distributors
100% silcone translucent outer sheath, 8mm lead set with stainless steel wire spiral bound wire giving instant and greater resonance, Kevlar fibre core and a ferromagnetic layer for EMC suppression by Luminition. Top end of ignition lead sets.
The black vinyl covering that lays on your lower dash shelf. For cars after 1970 where the facia panel is not a full metal panel you must fit (link)DT3076(/link)
A plastic lamp spade connection with sidelight bulb aperture for use on sealed beam units only. Uses a GLB501 capless bulb. The mini clubman used sealed beams but had independant side lamps and therefore had an equivalent unit less the s...
Dash liners without air vents for either side of the speedo on deluxe versions such as the Cooper S with centre speedo and two gauges which are black vinyl covered as opposed to the painted type. Not for the single centre clock only.
see [li...
The only battery cable to run the full length of the Mini, this has a positive type terminal that clamps arond the post rather than the helmet or cap type on much earlier cars. Some cars had slightly shorter cables than this but measure your old cabl...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.