THROTLE CABLE LEVER BAR ASSY. (ARDEN EIGHT-PORT)
DR004

($40.00) £40.00 exc vat

($48.00) £48.00 inc vat

In stockIn stock

($40.00) £40.00 exc vat

($48.00) £48.00 inc vat

In stockIn stock

Recommended usage 1 x DR004 to fit one mini.

Kit products

Amal carburettor kit for the Arden 8-Port head. Complete with carbs, manifolds and linkage.

People also bought products

A very usefull tuning needle for single and twin carbs when camshaft change for carbs with floating needles.

Probably the most changed stud on the mini. This is the length used on every A series engine until the introduction of the sandwich plate when longer ones were required. A stainless steel variety C-STR286 is available which we do recomme...

Complete with screw the choke trunnion is used on nearly all SU carb linkages.

See ACC5062 for carb cable link trunnion also.

Pin to hold the accelerator cable which locates in the carb bracket lever. Supplied as originally fitted with washers, nut and split pin plus a proper machined hole for the cable unlike many others on the market- which come either bare or with wrong ...

These spherical rod ends are also known as a Rose joint which is a registered trade mark. We use these ends on some of our weber carb linkage kits and anti roll bars. This is the male type threaded joint.

This fitting kit suits all later day 1.25" and 1.5" twin carb set ups where the balance rods between the carbs required are equal length (2.25"), some early carbs had the balance bar with a triangular plate that were a shorter length. The kit has the...

Minispares UK manufactured seal for the non locking standard petrol caps it is now made of a petrol resistant material that will fit any genuine petrol cap.

It has a 60mm outer diameter and a 39mm internal diameter hole which is close enough...