DISTRIBUTOR ALDON RED A PLUS
ALDONRPLUS

(162,68 €) £162.68 exc vat

(195,22 €) £195.22 inc vat

In stockIn stock
This is a race or high performance disributor for A Plus engines and can be fitted with points or LU143A ignition pack can be fitted as an extra

Distributor drive spindle if required is 12G3560

Distributor clamp plate is TAM1671

Bolt for clamp is [linkTAM17076[/link]

(162,68 €) £162.68 exc vat

(195,22 €) £195.22 inc vat

In stockIn stock

Recommended usage 1 x ALDONRPLUS to fit one mini.

Alternative products

The all new 123 Electronic distributor is now available at Minispares. Featuring 16 ready programmed switchable advanced curves built in as standard, a must for any mini with a worn distributor. Full instructions are included with the system. For any...

These performance road type distributors are for A Plus engines and can be fitted with points or LU143A ignition pack can be fitted as an extra

For best performance and modern day fuel/camshafts and tune we advise our electronic evolution v...

People also bought products

Electronic ignition conversion. For points type distributors, fixed or sliding. Negative earth only. Also, available for earlier 23/25D on Negative earth (LU142) or earlier 23/25D with Positive earth (LU142AP12).

ONLY use GCL217 coil for bal...

These performance road type distributors are for A Plus engines and can be fitted with points or LU143A ignition pack can be fitted as an extra

For best performance and modern day fuel/camshafts and tune we advise our electronic evolution v...

Electronic ignition kit to fit 45/59D4 distributors.

Designed to do away with points this is a simple drop in installation to fit into your existing distributor. Also see our range of distributors with built in electronics--BAU1962MS & [lin...

This distributor clamp should not be bent; if it is, either you can't get the dizzy all the way in or it won't grip.

Prong type clamp that bolts to the block and retains the A plus distributor in place. The screw is TAM1706.

Pre A plus clamp is 501134

This distributor is for Pre A Plus race or High performance engines and can be fitted with points or LU143A ignition pack can be fitted as an extra

Best on the market, sports coil-Not Lucas. A standard coil can only do so much, and when compression is raised (as in most high performance engines) or improper fuel mixtures occur something better is needed. This sports gold coil with proven origina...

A favourite for specials where room is at a premium and easy access is required for 45D type distributors only--uses GRA2128 rotor arm and obviously discard screws from cap and use existing distributor clips to secure.

some caps...

Original mini coil fitted to all cars up to 1983.

3ohms

NOT for ballast type ignition systems.

Our research, sales and feed back shows Intermotor coils to be the best available for the mini.

Original type coil bra...

These points were fitted from 1974-80 when the distributors became a 45D type,

the distributor cap shape changed also to GDC136 and likewise rotor arm GRA2114 and condenser GSC2109.

MK1/2/EARLY MK3. 3 position spring loaded type. Comes with barrel.

For barrel only use part number 24G1345.

Slightly hotter running engine plug for A Plus 998 and all 1275cc standard engines. For engine running CR of 9.4 to 10:1

The original blue rotor arm was fited with a blue cap GDC143 to the turbos and were made stronger by moulding and riveting the contact plate to the arm, so if you are looking for an upgrade on your 45D body distributor this is our altern...

100% silicon insulation, silicon coated suppressed conductor,braided glass reinforcement,increased working temperature 0f minus 50C to +300 degrees with improved resistance to damp and water, great fitting and spiral bound wire giving instant and gre...

A higher compression engine should have a colder spark plug. The engineers explain that it has to do with flame temperature and overheating the plug. I know from experience that my race engine will melt a street plug. Choose from the following NGK pl...

100% silcone translucent outer sheath, 8mm lead set with stainless steel wire spiral bound wire giving instant and greater resonance, Kevlar fibre core and a ferromagnetic layer for EMC suppression by Luminition. Top end of ignition lead sets.

Great plug for tuned high compression engines and turbos this plug is gold palladium tipped for good ignitability on low voltage. Now supersedes to BR8EIX Iridium.

Blue in colour these points were used on the latest 59D type distributors from about 1980 on up to the introduction of electronic distributor with only rotor arm."Sliding" points for 59D4 distributors, keep a spare set!