(13,89 €) £13.89 exc vat
(16,67 €) £16.67 inc vat
Out of stock
(13,89 €) £13.89 exc vat
(16,67 €) £16.67 inc vat
Out of stock
Pipercross KK150 chrome top, low-conical, foam air filter for 1.75" SU carb.
Full flow, high capacity competition foam air filters; the KK range of Pipercross high performance air filters offer the ultimate in engine filtration, and are...
Special rubber hose 1/4" bore for use on petrol lines, this is in black and not armour plated outside but does have internal reinforcing. Supplied as pre cut 1m length with 2 clips and is safe to use with modern fuels with higher ethanol content. SAE...
Our heavy duty throttle cable is superior in many ways.
A nylon interior ensures smooth operation. The outer cable is 32mm longer and inner is 95mm longer than the standard one.
Cable to carb bolt is ACC5062.
Clip on the heater valve for heater cables on vehicles from 1990 where the in line remote heater valve was used. It has also been used as a clip for HIF carbs to hold the cable but the one from Rover is 13H3472.
Correct and original thickness oil for SU carb dashpots.
GASKET BETWEEN CARB AND AIR CLEANER ALLOY ELBOW
Carb to manifold spacer with facility for fitting a vacuum gauge. This is suitable for HS6 and HIF44 and is 6.3mm thick.
Throttle return springs for all twin carb variants. Usually 3 fitted.
Probably the most changed stud on the mini. This is the length used on every A series engine until the introduction of the sandwich plate when longer ones were required. A stainless steel variety C-STR286 is available which we do recomme...
Locating rings originally made for 12G295 heads with twin carbs to line up the inlet manifold to the inlet ports on the cylinder head it found its way on most twin carb factory produced cars. There is a recess in the inlet port on the he...
Mini Spares own performance upgrsded paper gasket that sits either side of the carb to manifold spacer on HIF38/44 type 1.75" carbs.Sold singly, order quantity as required to suit your car.
Chrome top crankcase vent filter with metal 1/2" inlet flange, 47mm filter diameter x 1.5" high(40mm). Another cleanable filter from K&N.
Highly polished chrome cover cone filter.
The cotton gauze filter design from K&N provides positive gain that you would expect. Average filter life is 100,000 miles.
'Conical' 5.875" diameter x 2" high, fits 1.75" SU carb.
...
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps.
If you need the 5/16...
The clip that holds the choke cable on cars from 1987 to 1991
5/16" bore petrol/diesel hose which is sold per metre - also useful as hose for emission or evaporate loss control pipes and expansion tank to radiator use. Suitable for ethanol based products such as modern day fuels. 50psi max. R6 spec.
The Maniflow steel intake manifold has established the standard by which all others measure themselves. This manifold is specially designed to maximize air flow within the space requirements of a Mini. It accepts either twin 1 1/2" or twin 1 3/4" ...
The correct one for the origianl HIF44 carbs fitted to 1990-92 1275cc Coopers
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.