(249,38 €) £249.38 exc vat
(299,26 €) £299.26 inc vat
In stock
There is NOT enough clearance room when fitting to old cars with rubber couplings which foul.Using QL5000 type couplings will help but re-shaping of manifold is still required in most cases.
(249,38 €) £249.38 exc vat
(299,26 €) £299.26 inc vat
In stockRecommended usage 1 x RC40PACKAGE004 to fit one mini.
The popular RC-40 exhaust system has been updated as the millennium range from the year 2000. All retain the optimum size 1.75" tubing for maximum performance and efficiency, but we now offer a choice of tailpipe size and configuraton. In addition, t...
When fitting to an LCB cut 5-8" off.
This downpipe and centre box are made the correct length for the freeflow manifold but when fitting to a LCB the flanged end should be cut off 5"-8" from the end. The downpipe and exhaust shoul...
Complete mounting kit for the RC40 exhaust. Includes all new rubber mounts, brackets and clamps.
Standard bore LCB (1-3/4"id) that is ideal for very hot small bore engines, for standard to high performance 1275s and for street 1380s.
There is NOT enough clearance room when fitting to old cars with rubber couplings which foul. Using [lin...
Standard bore Budget priced LCB (1-3/4"id) with pre cast flanges to improve flow and save engine tuners time matching the ports. This is ideal for very hot small bore engines and for standard to high performance 1275s, including road 1380s.
Aftermarket union for fitting all mini inlet manifolds where a take off is required for your brake servo or emission valve on Cooper S cars.
The intake/exhaust manifold should be secured to the head with brass nuts and these very thick washers. These washers are intended to not only spread the clamping action but the thickness allows them to absorb the heat without deforming! Takes 4 per ...
This is the clamp for the C-AEG365 manifold that clamps it to the engine for extra support.
Locating rings originally made for 12G295 heads with twin carbs to line up the inlet manifold to the inlet ports on the cylinder head it found its way on most twin carb factory produced cars. There is a recess in the inlet port on the he...
Manifold gasket fitted to all A series pre 1992 except Turbo which had a reinforced exhaust ports GUG704063MG and SPI from 199. From 1991 on a new better gasket with reinforced exhaust ports and backing was fitted GUG704053MG
This bracket bolts on the gearbox and attaches to the exhaust front downpipe clip GEX7053.
Clamp on the front downpipe that fits to the bracket on the gearbox (GEX7526)
these are also supplied on our new 2 piece exhaust.
Genuine mini Spares inlet manifold dyno tested and designed for our Stage one kit C-STN17. The single SU manifolds is developed to give maximum airflow and gas speed, yet fit all engines even if the standard air cleaner set-up is used. I...
Complete mounting kit for the RC40 exhaust. Includes all new rubber mounts, brackets and clamps.
The newest development in the A-series engine is the use of these nuts with swedged-on washers. The washer will not separate from the nut, so you won't lose it. Yet the nut rotates independently while you tighten it. What a great idea.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.