Manifold stud for all A series injection engines and some late carburettor cars which is 45mm long-6mm longer than 53K487.carburettor engines usually retained the 53K487 shorter screw for the outside 2 holes.

Sold singly,6 per c...

Smarten up your engine bay with these stainless steel studs and nuts which are not only stronger and resistant to rust but the multi point nut heads are easier for access.Quantity required one kit per car

A more robust cast version on GEX7801.



Twin Down pipe clamp for Carb Coopers 1990 on wards, and Metro's.

Also used as a single clamp on manifold for cars fitted with HIF38 carb cars from 1991 on.

Fitting kit comprising of studs, nuts, plain washers, spring washers and a gasket

ARP Head stud kit that compromises of;

4 x Long Head Studs

7 x Short Head Studs (Disregard 2 if you're using a 9 stud application)

11 x Multipoint ARP nuts

11 x Heavy Duty Washers

4 x Rocker post studs <...

New competition valve cotter, these are precision CNC machined from 4340 and heat treated to a better spec than EN24T and claimed to be stronger in fatigue life.

These locate better in the valves and easier to control spring heights.

Complete stud, nut and washer kit for the cylinder head ancillaries. Kit contains parts to retain the following:

Inlet/Exhaust manifold to head, studs/nuts/washers

Thermostat housing (no sandwich plate) studs/nuts/washers

H...

Minispares own stainless steel Thermostat housing stud kit for the single tier type thermostat housing.Quantity required one kit per car

This is the clamp on the cooper freeflow manifold to clamp it to the engine for extra support, supplied with tag.

Injection models-Standard bore Budget priced LCB (1-3/4"id).

With pre cast flanges to improve flow and save engine tuners time matching the ports. This is for injection type cars only because it has a sensor hole. The Long Centre Branch des...

A true Cooper S engine has 10 studs and one specially designed bolt.

Spacers for under the rocker pedestals are used mainly by engine tuners to allow tappet adjustment to be made where cylinder head mods have been carried out. 1.3mm/0.0512" thick, this can be used to hold locating screw on rocker post assembly but the...