£500.93 exc vat
£601.12 inc vat
£500.93 exc vat
£601.12 inc vat
Recommended usage 1 x C-BTA1226 to fit one mini.
New Minispares Evolution straight cut crownwheel and pinion set 3.875. The crownwheel in these kits has a 20% wider gear than previously supplied, and a pinion made from Aero quality steel making it 20% tougher.16x62 teeth count
Always Check...
These are the larger bore diff side covers when hardy spicers are fitted and they also have the flange to cover detent spring on side if fitted to rod change when converted to hardy spicer. Has a 50mm oil seal o/d and bush size 34.8mm.For the yoke o...
A bronze type bush that fits in the gearbox output shaft side cover on early automatics and Cooper S with hardy spicer type joints. These are larger than the standard mini or rod change engine gearbox types which take 2A3538.
The gearbox diff side plate bonze colour bush for all except auto and cooper S with hardy spicer output shafts. Sold singly 2 required per gearbox.
clearance needs to be 0.03mm
This little roller bearing goes inside the end of the 1st motion shaft on minis with 14mm mainshaft which it sits on.
This bearing was previously part number 88G409 and a true Rover replacement, but if you have earlier A type gears with the...
The bronze bush in the differential housing that the gear change selector rod sits through which should be lightly greased.
Often overlooked when doing gearbox rebuilds this seal is very important as it sits in the very bottom of the case and is the source of irritating oil leaks.
The large round metal plug in the bottom of the gearbox is the pivot pin for all th...
Bearing 26.9mm wide to take 19.05mm idler gear shaft that fits in the gearbox case and clutch housing case on 4 synchro gearboxes until introduction of A plus when a larger bearing was fitted.
When in doubt replace it. You have heard this many times but you better believe it on this part. If you have not personally just replaced these layshaft bearing then do it now while you have the chance. These bearing will destroy the inside of a very...
Drive shaft oil seal or diff output shaft oil seal for all Mini's except Cooper S and early Automatics. 2 required per gearbox.
Upgraded version in Viton available us ADU5738VITON
Pre A plus 4 synchro laygears had 2 of these fitted plus a small bearing whereas the A plus laygear had only one.
This seal fits the hole just above the diff housing where the rod comes out that holds the male gear change knuckle on remote and earlier magic wand gearboxes. Not on Rod Change types.