Brake and clutch pedal pads contribute to comfort and safety. They also add that final touch to a nice interior. GPR104 fits brake and clutch pedals of MkI & MkII Minis up to 1976 and the throttle pedal on post 1976-1996 models.

gives you car the look of the 1997 onwards twin point cars,but fits on to cars built from 1976 (mk4) with larger accelerator pedal. It will not fit any twin point injection cars but is a copy made to fit 1976 to 1996 including single point injection ...

Brake or clutch pedal pad for MK3 Mini.

This switch fits under the brake pedal on the floor. See also BMK1903A locknut for this item.

Special plastic covered clevis pin(first one to appear on a mini) is for the later brake system with servo and intoduced on single point injection.

ALLOY PEDAL PADS, RACE LESS FITTING SCREWS OWING TO USE. 68mm x 58mm

This easy to install metal extension clamps right on to the existing pedal. While it wont make the car any faster, it will make driving more leasurable. Will only fit pre 1976 cars with small pedal.

Interior lamp with a black on/off switch and pointed torpedo ends.

Also fitted many of the 1959on range of Austin A55/60 Cambridge, MG Magnette etc.

Also there was an alternative lamp with black switch and square ends 13H192 which w...

Rear 3 point fitting static seatbelt in grey.

Door panels in Red for MK1/2 doors less the fillets. This door panel design was used on all saloons & travellers from 1959 until 1970 when the door itself was redesigned. The panel slides into the door aperture and is held in place with a pair of doo...