Special thread cutting screw 1/4 UNF 1.25" (31mm) long.

Screw to hold the lock assembly on the door of MK3 cars with internal hinges and wind up windows. On new doors or for easy fitment use these special screws with cutting thread (3 sided ...

M10 metric flanged bolt 35mm long for catalytic converter. (4 required per unit)

There are 3 of these bolts fitted -1.75"long 5/16"UNF bolt ALTERNATIVE DAM7758.

Also used as longer bolt for water pump.

Also for the 21A1091 heavy duty tie rods on front suspension.

Bolt for CHM85 differential side cover. 1" long UNC useful for pre verto slave cylinder and starter bolt. Also 12A361 engine mounting bracket to alloy case.

Bolt used in our anti roll bar kit and for holding plate on speedo drive housing on gearbox

Bolt for the overider to lock plate at the back of the overider to secure it against the bumper.

Also has been used for the rear subframe trunnion 2A5819/21A2558.

Also used for the short water pump bolt.

There are 2 of these long high tensile bolts in each tower of the front subframe on pre 1976 cars to hold it in place on the bulkhead. Do not forget to renew the locktab 21A1470 on these bolts. Not suitable for hydrolastic cars - see [l...

Assorted high tensile UNF setscrews with approx qty:



30-3/16"x1"

25-1/4"x3/4"

20-1/4"x1"

15-1/4"x1.5"

25-5/16"x3/4"

15-5/16"x1"

10-5/16"x1.5"

10-3/8"x1"

Bolt for the bottom of the inner steering column to lock it onto the steering rack spline. This is a Rover special fitting bolt with a 1/2" plain shank to fit the inner steering column groove.

As it is an expensive bolt, for any other purpos...