BOLT 5/16"X 1.5" UNC SETSCREW
GFK5235

£0.35 exc vat

£0.42 inc vat

In stockIn stock

£0.35 exc vat

£0.42 inc vat

In stockIn stock

Recommended usage 1 x GFK5235 to fit one mini.

People also bought products

Engine mount bolt kit for manual cars, 1 kit requried per car.

5/16" UNF THREAD 2 1/2" LONG bolt commonly used for 21A2838 petrol tank strap

Stainless steel version of GFK5184, worth keeping a few spare as they are one of the most common bolts fitted to the Mini.

Bolt for the top alternator bracket on mpi cars.

Stainless steel version of GFK5185, worth keeping a few spare as they are one of the most common bolts fitted to the Mini.

Clutch housing bolt to engine long 5/16" UNC 1.75" long Fitted ffrom 1985 for clutch housing instead of 22A152 stud

Special thread cutting screw 1/4 UNF 1.25" (31mm) long.

Screw to hold the lock assembly on the door of MK3 cars with internal hinges and wind up windows. On new doors or for easy fitment use these special screws with cutting thread (3 sided ...

Clutch housing bolt to engine long 5/16" UNF 1.75" long with tuflock patch to secure. Earlier bolts less tuflock are {link]BH605141{/link}

Self tap screw No10 for holding wiper motor strap to body and any other use.

M10 metric flanged bolt 35mm long for catalytic converter. (4 required per unit)

New set of metric studs, bolts, nuts and washers as supplied with the alloy external hinge kit (PEASE NOTE: This kit is NOT suitable for the original hinges). The studs have allen key socket ends to help put them into the hinge easily without damage,...

Remote type gearboxes had four UNC bolts holding the long alloy housing to the differential case. These are the shorter two, 3/8"unc 1"long. The longer two are ZCS628.

Also the bolt to hold the starter motor.

Also the bolt for the [...

There are 3 of these bolts fitted -1.75"long 5/16"UNF bolt ALTERNATIVE DAM7758.

Also used as longer bolt for water pump.

Also for the 21A1091 heavy duty tie rods on front suspension.

Bolt for CHM85 differential side cover. 1" long UNC useful for pre verto slave cylinder and starter bolt. Also 12A361 engine mounting bracket to alloy case.

Front subframe to front teardrop mounting, clutch case to block.

Engine mounting to subframe - easier to use than the GFK5184 - 3/4" long

Bolt used in our anti roll bar kit and for holding plate on speedo drive housing on gearbox

This 5/8unf steel hexagonal head blanking plug was made for the inlet manifolds where the servo union can be fitted, plus blanking off the thermal transmitter hole under the thermostat. Uses 1B3664 washer ----------please note this will ...