Special locking washer for 3rd gear on 4 synchro gearboxes plus our own 5 speed 5th gear. The washer for 2nd gear is 22G839

Minispares recommend this central oil pick-up be installed with every transmission rebuild.

The original Mini oil pick-up pipe lives in the right hand edge of the gearbox casing, which is okay if you are driving straight. But during a right ...

The favourite final drive for minis this is the pre A plus type which was stronger and fitted to Cooper S etc. goes with 22A411 crownwheel.

19 tooth pinion for 3.1 and 3.2 final drives with 3 groove mark

list below for other markings

17 teeth central groove

18 teeth offset groove to one edge

19 teeth 3 groove markss

See also DAM3108.

Genuine RHP bearings. Not cheap Imported rubbish as sold under this part number.

This is the workhorse of the Mini gearbox. This double roller bearing supports the shaft where it transmits the power to the wheels. When this bearing goes, the...

You will need to shim up your diff bearings with these washers as required. See workshop manuals for details. See also DAM3109 & DAM3633.

Torrington/Koyo idler gear bearing with special rollers for allowing movement on late type idler gears. The idler gears for twin point cars were also made from clean steel as an upgrade from 1996 on. This special bearing replaces the cheaper inferior...

Often overlooked when doing gearbox rebuilds this seal is very important as it sits in the very bottom of the case and is the source of irritating oil leaks.

The large round metal plug in the bottom of the gearbox is the pivot pin for all th...

Inside your gearbox synchro hubs are 3 springs and these ball bearings to lock it in and out of gear. Often pop out and get lost when splitting the inner and outer hub.

Lower differential housing paper gasket for old magic wand and remote type gearboxes, rod change gearboxes.

Genuine RHP as originally fitted to every production Mini.

Two of these main diff carrying bearings are required in the gearbox and this new steel caged type fits either way round. Should be pre loaded by 1-2 thou.

Some original fi...

Genuine 1ST Motion shaft SINGLE track original bearing for 4 synchromesh 1st motion shaft.

This is a Genuine RHP bearing, and should not be confused with cheap alternatives. The cheap aftermarket bearings often fail and the work involved to...

Minispares were the first company to produce these layshafts for performance engine/gearboxes as the standard type would flex and resullt in the breakage of the bearings causing seizure. Produced in an upgraded material and heat treated to the correc...