(¥3) £3.05 exc vat
(¥4) £3.66 inc vat
In stock
Torque setting 30 to 35 lb/ft or 4.1 to 4.8 kg/m.
Sold singly 2 required per steering arm to hub-4 per car
(¥3) £3.05 exc vat
(¥4) £3.66 inc vat
In stockRecommended usage 4 x 2A4315 to fit one mini.
Locktabs for under the steering arm bolts on all minis. Fits either side.
Sold individually
Set of 4 High quality Japanese sealed ball joints.
Developed and tested over a period of three years, the original concept was to manufacture a high quality product, similar to those used on modern vehicles. Unlike the current des...
High quality sealed ball joints from Mini Delta Japan.
Developed and tested over a period of three years, the original concept was to manufacture a high quality product, similar to those used on modern vehicles. Unlike the current ...
This dark woodrim steering wheel requires a centre boss to suit your particular car and is the best value and quality wheel around in its class. Brightwork 3 spoke
centre design.
This woodrim steering wheel requires a centre boss to suit your particular car and is the best value and quality wheel around in its class. Brightwork 3 spoke
centre design.
Mini steering racking fitting kit comprising of 2 U-bolts, 4 nyloc nuts, 2 plastic anti friction stipes, the foam rack to body seal and the half nuts to lock the track rod ends
Screw for MK4(1976) onwards steering cowl at dash end.
Nylon bush for original C.A.M steering racks fitted by Leyland/Rover.
Motalita steering wheel boss for MK1 minis only with green light indicator stalk and centre cap horn push.
For all MK4 minis from 1976 until 1996 air bag models arrived.
Models from 1989 on only have one cancelling pin,match the boss to the existing wheel and remove unwanted pin.
Required to fit Mountney wheels to your Mini. The Mkl adapter Black boss has a built-in horn-push. The Mkll (BOSS/V3) is for cars with the horn on the stalk.
Special shaped U bolt for holding the steering rack in place. Every mini uses 2 of these and make sure you fit the 21A2553 plastic anti friction strips. Sold singly
The sponge dust shield that fits over the splined area of the steering rack as it bolts up against the bulk head. Usually it is sold with the centre part cut but not pushed out, but it pops out easily and is shown on our picture as a reference only. ...
Quickracks-If you are interested in performance driving then you know reaction time from the driver to the car is critical; the time it takes to turn the steering wheel to the desired angle is important! The standard rack is 2.7 turns lock to lock, o...
This woodrim steering wheel requires a centre boss to suit your particular car and is the best value and quality wheel around in its class. Brightwork 3 spoke
centre design.
A bit larger than the MK1 to accept the improved indicator switch this fitted
MK2 and MK3 cars until the introduction of the steering locks.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.