(¥35) £35.00 exc vat
(¥42) £42.00 inc vat
In stock
For Mk1/2 see MSP005L
(¥35) £35.00 exc vat
(¥42) £42.00 inc vat
In stockRecommended usage 1 x AHP36007 to fit one mini.
BARE BULKHEAD SKIN
THIS IS THE LATER MPI PRESSING, BUT CAN BE CONVERTED TO SUIT EARLY CARS BY EITHER CUTTING ROTADIP HOLE YOURSELF, OR BY FITTING THE PRE FORMED HMP441017
A VERY CHEAP PANEL THAT CAN BE CUT TO MAK...
Rear subframe mounting stiffener L/H repair bracket with holes for subframe mounting and attaches to wheel arch Fits on ALA8623
Metal floor plug as per original with rubber seal.
For use in 1" hole.
Non genuine rear companion bin for external hinge cars. These are supplied without the ash try mount.
Non genuine rear companion bin for external hinge cars. These are supplied without the ash try mount.
The last type of rod change rib design floor made for the assembly line fits cars from 1997-2000. It has a large rib down the centre of the L/H side.
This floor produced from genuine tools has the crossmember fitted with the sill panels an...
non genuine L/H outer MK3 door skin lower few inches repair section.
not as good a fit or looking as the genuine complete skinCZH3301
Non genuine L/H saloon inner sill. Only made as an after market replacement as no genuine part was ever available seperately. Best one on the market for a comlplete inner sill replacement panel. With carpet fix brackets.
part inner wing L/H from Damper bracket mounting pointing forward for SPI modles 1991-96 with large round electric radiatore fan hole
NON genuine panel
Non genuine repair panel for below the lights and above the rear valance, fits all models. Right hand side.
Non genuine repair panel for below the lights and above the rear valance, fits all models. Left hand side.
Bracket on the end of the dash crossmember(x member holds master cylinders) under bonnet right hand side. The x member is AHC36003
Small reinforcement bracket panel between the inner and outer sill on the LH side rear. The 24A43 slinger sits underneath this bracket under the sill panel.
Small reinforcement bracket panel between the inner and outer sill on the RH side rear. The 24A42 slinger sits underneath this bracket under the sill panel.
Small reinforcement bracket panel between the inner and outer sill at the front, these are the same both sides.The 24A41 slinger sits underneath this bracket under the sill panel
Small lower repair section of the rear quarter panel, if you need the door step section also see part number MS28R.
For Mk3 but can be used as a part of repair sectiion for Mk1/2
O/S/F wing t for 1996 on cars. THIS WING STILL NEEDS MODIFYING to allow for fitting of Sportspac arches and 13" wheels. After trimming/cutting to size remember to replace or renew the stiffener lip ALR360380
Has the headlamp re...
Upgraded L/H "A" panel for all Minis with internal hinges,1970 on.
A single wall panel has has a tendency to develop rust spots and is probably one of the most common panels replaced on the Mini.
Only available from Mini Spares th...
Upgraded R/H "A" panel for all Minis with internal hinges,1970 on.
A single wall panel has has a tendency to develop rust spots and is probably one of the most common panels replaced on the Mini.
Only available from Mini Spares th...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.