(¥325) £325.00 exc vat
(¥390) £390.00 inc vat
In stock
whole rear section from roof to bumper valance with MK2 lamp holes,bootlid and backlight holes to fit al models from 1967 to 2000---if you require this rear panel with MK1 rear lamp holes as a retro fit see HMP441046
Fitted with roof cantrail 14A6596
(¥325) £325.00 exc vat
(¥390) £390.00 inc vat
In stockRecommended usage 1 x ALA6417 to fit one mini.
genuine rear lower back panel for MK2/3 on, which goes up as far as lower edge of backlight seal ridge
Rear subframe mounting stiffener L/H repair bracket with holes for subframe mounting and attaches to wheel arch Fits on ALA8623
The gasket that sits behind the door stiker on all wind up window type minis
on the B post.
Non genuine double skin MKI boot lid. Always fix your swinging number plate and hinges on for dummy fit and alignment before spraying.
This is the only double skin bootlid avaialble.
The Genuine double skin Mk2 type 8G927...
Non genuine rear companion bin for external hinge cars. These are supplied without the ash try mount.
Complete set of bolts to mount the front subframe on all post 76 single bolt subframes less the large tower bolts and towing eye, enough fixings are supplied for those who wish not to use a towing eye.
Tank strap bracket welded to the rear of the boot floor which the single diagonal tank strap 21A2838 attaches to.
Body side rear lower w/arch to rear section of bodyside repair L/H. 220mm tall.
Repair section of bottom of door for external hinge cars, MK1/2.
This crude non genuine parts is the only repair section available for early doors apart from door skins.Lots of stretch marks and wrinkles but they have been fitted by customer...
Repair section of bottom of R/H door for external hinge cars, MK1/2.
this crude non genuine parts is the only repair section available for early doors apart from door skins. Lots of stretch marks and wrinkles but they have been fitted by cus...
Body side rear lower w/arch to rear section of bodyside repair R/H. 220mm tall.
Genuine Mini Spares product. The seal that goes on the neck of petrol tanks as protection against water intrusion and to also to make the hole look neater, so replace them when they crack or shrink through heat. This is the original fatter type as us...
Rear seat belt anchor mounting point as found on later cars. This panel needs to be welded into the C post.
Rear seat belt anchor mounting point as found on later cars. This panel needs to be welded into the C post.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.