3 layer steel head gasket especially suitable for full race engines up to 73.5mm

bore where it has larger bore holes and considered the ultimate head gasket.

Especially recommended for 8 port heads as it has no fire/compression ring...

Mini Spares cam follower with original convex bottom Radii as used by BMC/Rover and made by Clanceys but less the oil hole. Using Clancey drawings and to our design for better cam performance and lift we have made the push rod recess deeper for stabi...

30.93mm(1.218") exhaust valve for 8 port pre 2012 specification only

this valve is longer than other A series varieties and plasma heat treated to eradicate wear from unleaded petrol.98.35mm total length. 3.879 "

The valves for the ...

35.6mm(1.405") longer inlet valve for the original 8 port head pre 2012 spec only for use with silicon bronze guides these are plasma heat treated to eradicate premature wear from unleaded petrol.

The valves for the current 8 port heads from...

Mini Spares spacer kit re-designed in 2005 for correcting rocker alignment.

This kit has been produced to help rocker pad and valve stem alignment plus reducing friction. The standard springs can be replaced with this special kit of 3 spacer...

Turbo oil pump, highest flow available. 9 Gallons per minute as against approx 6 GPM. This pump is a late model slot drive and will fit into any 1275cc engine and exactly the same as the second generation of pump as sold by Unipart/Rover.

Ga...