HORN LOW TONE SINGLE TERMINAL
GGE101

(¥12) £11.66 exc vat

(¥14) £13.99 inc vat

In stockIn stock
A working car horn is not only a necessity it is also a legal requirement in England and most other countries.This the single spade terminal with an open trumpet

(¥12) £11.66 exc vat

(¥14) £13.99 inc vat

In stockIn stock

Recommended usage 1 x GGE101 to fit one mini.
Horn & Windscreen Wiper - Qty 1

Alternative products

A working car horn is not only a necessity it is also a legal requirement in England and most other countries.This the single spade terminal with an open trumpet

People also bought products

twin terminal horn with low tone and open trumpet design-often fitted with the hi tone version GGE164 to let people know you really are there.

A working car horn is not only a necessity it is also a legal requirement in England and most other countries.This the single spade terminal with an open trumpet

Horn push assembly for the Mk1 Austin Mini, Mk1 Austin Mini Cooper and Mk1 Austin Mini Cooper S.

For Morris cars, see 27H6944. This horn push assembly can also be supplied without a centre emblem, see 27H6945

All the horns we sell have a bracket on them but this is the original type from Rover.

A working car horn is not only a necessity it is also a legal requirement in England and most other countries.This twin upgrade open trumpets is just the set you need to be heard.

A working car horn is not only a necessity it is also a legal requirement in England and most other countries.This is going one better with air horns that have open red trumpets.

twin terminal horn with high tone and open trumpet design-often fitted with the low tone version GGE165 to let people know you really are there.

Horn push assembly for the Mk1 Morris Mini, Mk1 Morris Mini Cooper and Mk1 Morris Mini Cooper S.

For Austin cars, see 27H6943. This horn push assembly can also be supplied without a centre emblem, see 27H6945

Wiper motor fitting kit to fit all mk2 onwards wiper motors to the bulkhead.

Main wiring grommet that fits in the front parcel shelf. ID 12.5mm fits 35mm hole.

Interior lamp with a black on/off switch and pointed torpedo ends.

Also fitted many of the 1959on range of Austin A55/60 Cambridge, MG Magnette etc.

Also there was an alternative lamp with black switch and square ends 13H192 which w...

Battery bar and fitting kit for all post 1990 cars whcih had the longer battery bolts.

Battery bar and fitting kit for all pre 1990 cars whcih had the shorter battery bolts.

Electronic ignition conversion. For points type distributors, fixed or sliding. Negative earth only. Also, available for earlier 23/25D on Negative earth (LU142) or earlier 23/25D with Positive earth (LU142AP12).

ONLY use GCL217 coil for bal...

Sports coil for ballast resistor type ignition.

Best internal parts tested and another intermotor top product.

Its not the name on the outside but whats on the inside which matters.

Original type coil bracket 12G29...

This is the hazard switch repair plug for post 1976 rocker switches, pins supplied so you can wire accordingly.

Lots of things have been written about performance plug ignition wires but regardless of what you believe we all know that good wires are a must. This special competiton wires set from the Lucas factory has 8mm wire and the highest performance, no br...

Small battery cable retaining bracket bolted at the front of the engine for pre engaged manual cars approx 1985 onwards.

Wiper Swithch MK1/2/EARLY MK3 blade type switch for using to convert to 2 speed wipers when current 2 speed wiper motor is used.

For modern day petrol, except 1275cc. See 37H8379MS for 1275cc.

After lengthy tests we have found nearly all vac units are not to the originals but with the change of added oxygenates to petrol in the 1980's and then ethanol in ...