Screw for holding the needle guide on HIF44, HIF38 carburettors. Also fits HS6.

complete rebuild kit for Turbo type HIF44 carbs including needle valve and throttle spindle plus disc.With damper clamp ring as fitted to turbo only

This tool/gadget allows you to balance both air intakes on either twin SU or twin choke carbs so they flow exactly the same to give better performance and economy.

This float is ethanol tolerant and will fit all HIF38/44 carbs and the spindle is CUD2082 ..Quantity required-1 set for single carb.

Turbo uses WZX1095 needle valve. An expensive puncture proof stay up float is av...

jet assembly (0.100") for the HIF44 carb only- see MGM10008 for HIF38(0.090")

The little spring that sits at the end of a spring loaded carb needle on late HS and all HIF carbs where applicable.

Known as a swinging needle because they sit on a spring which locates into the hat/cup end of the needle and have sideways movement. They start with part number prefix CUD for HS type carbs--NZX for HIF carbs--the earlier H and HS type were fixed sol...

Twin carb HS2 (1.25")black heatshields with link bar and 3 new return springs.

Gaskets and spindle/float lid seals for all the HIF38/44 range.

For HIF38 service kit see CSK94 for mini and CSK78 for metro

for HIF44 see CSK75[/lonk] except turbo

[link]CRK167 rebui...

Clip on the heater valve for heater cables on vehicles from 1990 where the in line remote heater valve was used. It has also been used as a clip for HIF carbs to hold the cable but the one from Rover is 13H3472.