INNER WING AND FLITCH PANEL Mk1/2 L/H
14A7901

($200.00) £200.00 exc vat

($240.00) £240.00 inc vat

In stockIn stock
For vehicles with external hinges and sliding type windows this is a full inner front wing with the wheel arch panel. The panel is what that the outer A panels for the hinges attach to.This is the left hand pane wing with radiator vent slats but not the rad shroud panel which is available as 14A6498. For the MK1/2 saloon and vans ---Heritage panel but not 100% perfect cosmetically to look at.

($200.00) £200.00 exc vat

($240.00) £240.00 inc vat

In stockIn stock

Recommended usage 1 x 14A7901 to fit one mini.
Saloon and Front Ends - Qty 1

Alternative products
INNER WING L/H 19.5 DEEP REPAIR MINI
CZH3065

Part inner wing L/H from Damper bracket mounting points forward. MK1/2/3 except Clubman. This panel has radiator cooling slats as fitted to 1991

NON genuine panel only as part panel

($52.20) £52.20 exc vat

($62.64) £62.64 inc vat
People also bought products
MK1/2 TOE BOARD NON GENUINE
14A6487MS

MK1/2 toe board with steering rack mounts.

($149.85) £149.85 exc vat

($179.82) £179.82 inc vat
MK1/2 BULKHEAD CROSSMEMBER PANEL NON GENUINE
14A6486MS

Crossmember at the back of the engine bay where the master cylinders fit, fits MK1/2 models.



correct shape for a mark one unlike the laster version that is modified for carb clearance

($82.50) £82.50 exc vat

($99.00) £99.00 inc vat
BULKHEAD PANEL MK1 WITH AIR VENT HOLE
14A9563MS

MK1 front bulkhead skin to suit mk1 with the round hole for the heater trunk pipe. Bonnet hinge brackets not fitted.



Can be used in later models with some adaption.

($112.50) £112.50 exc vat

($135.00) £135.00 inc vat
CROSSMEMBER BRACE BRACKET MK1/2 RH
MSP005R

Crossmember to inner wing bracket bracket for Mk1/2 R/H

not mini clubman

($25.73) £25.73 exc vat

($30.88) £30.88 inc vat
FLOOR PAN VAN/ESTATE FRONT TO REAR LESS CROSSMEMBE...
24A604

Floor pan for Mini van/estate with no x member for remote change gearbox. Non Genuine. For saloon see 14A6491

picture is just to show what you get but bulge on centre tunnel for starter button appears to be on wrong side as this...

($510.00) £510.00 exc vat

($612.00) £612.00 inc vat
FRONT PANEL VAN/PICK UP 61-64 (NO VALANCE COOLING ...
14A6480

Non Genuine for the Pick-up and Van 1961-64 with a slat type fixed grille as a trademark for Mini commercial type vehicles originality.

Usually ordered for customers requirements as these are very rare models.

This panel has no b...

($195.00) £195.00 exc vat

($234.00) £234.00 inc vat
FRONT NUMBER PLATE BRACKET UNDER BUMPER LIP
14A8456

Small bracket under the front bumper lip to hold the number plate, sold singly.

($10.00) £10.00 exc vat

($12.00) £12.00 inc vat
DOOR CHECK L/H PANEL GENUINE
ALA6473GEN

L/H Inner hinge type A post repair panel with hinge fitting holes mini, MK3

this is a genuine heritage part.

($32.00) £32.00 exc vat

($38.40) £38.40 inc vat
DOOR CHECK R/H PANEL GENUINE
ALA6472GEN

R/H Inner hinge type A post repair panel with hinge fitting holes mini, MK3

this is a genuine heritage part.

($32.00) £32.00 exc vat

($38.40) £38.40 inc vat
WINDSCREEN LOWER SCUTTLE PANEL NON GENUINE
HMP441001MS

This Non genuine pattern panel has the holes for windscreen wipers and jets with barely an inch of pillar.

On cars from 1992/3 on check the original windscreen drain channel as the VIN numbers were stamped above the clutch master cylinder-wi...

($44.85) £44.85 exc vat

($53.82) £53.82 inc vat
FRONT PANEL MINI 1997->2000 MPI (FRONT MOUNTED RAD...
ASJ360070MS

Reproduction version os ASJ360070. For the twin point only as it changed shape to accommodate the front mounted radiator and different bonnet fittings.

($112.50) £112.50 exc vat

($135.00) £135.00 inc vat
BULKHEAD CROSSMEMBER COMPLETE
AHC36003

This is the crossmember for the dash at the back of the engine bay which holds the master cylinders. When fitting to Clubmans extra end pieces are required. Fits 1976 on but does not have PDWA valve bracket. The original Rover parts are supplied with...

($170.00) £170.00 exc vat

($204.00) £204.00 inc vat
INNER WING AND FLITCH PANEL Mk1/2 R/H
14A7900

For vehicles with external hinges and sliding type windows this is a full inner front wing with the wheel arch panel. The panel is what that the outer A panels for the hinges attach to. This is the right hand panel made by Heritage but not 100% perfe...

($155.00) £155.00 exc vat

($186.00) £186.00 inc vat
FLOOR EXTENSION PANEL FOR MINI VAN/ESTATES ETC
14A9023

Commercial Mini floor extension

It is an essential part for the correct restoration of all the longer wheelbase mini derivatives. From the original tooling.

($100.00) £100.00 exc vat

($120.00) £120.00 inc vat
WINDSCREEN CORNER PANEL L/H
MS6L

A non genuine panel made for repairing the corner of the windscreen panel which is prone to rust from water splashing up from underneath the front wheel arch.

Experience has shown its easier to fit the genuine panel HMP441001 al...

($16.88) £16.88 exc vat

($20.26) £20.26 inc vat
FRONT FLOOR PAN L/H PRESHAPED
MS25L

You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width with vertical flanges for easy installation and fairly well represent the original stamping. They have added metal to include...

($33.00) £33.00 exc vat

($39.60) £39.60 inc vat
MINI FRONT PANEL PRE 1976
MS4E

This early front (nose) panel will fit any Mini manufactured before 1976. It is probably easier to replace the entire panel than to repair a damaged one, especially if it's been hit more than once! Later Minis with rubber mounted subframes, use panel...

($89.93) £89.93 exc vat

($107.92) £107.92 inc vat
FRONT FLOOR PAN R/H PRESHAPED
MS25R

You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width with vertical flanges for easy installation, and fairly well represent the original stamping. They have added metal to includ...

($33.00) £33.00 exc vat

($39.60) £39.60 inc vat
INNER HINGE REPAIR PANEL L/H
MSL41L

1970 on, cars with internal hinges and wind up windows

This repair panel has holes for the hinges on A post and overlaps 3.5"(85mm)onto the wheel arch section of inner wing

($12.90) £12.90 exc vat

($15.48) £15.48 inc vat
HEADLAMP BOWL METAL
MS14

If your rusted old headlight bucket is getting to you, don't waste time trying to salvage it when new metal reproduction metal buckets are AVAILABLE.

With a headlamp rim fixing bracket 37H7421 attached

Whether you are ...

($20.40) £20.40 exc vat

($24.48) £24.48 inc vat