($28.50) £28.50 exc vat
($34.20) £34.20 inc vat
In stock
This is the inner hinge panel with the brackets on to reinforce the areas where the hinges sit. You will require the outer panel also 14A6901 for R/H and 14A6902 for L/H.
($28.50) £28.50 exc vat
($34.20) £34.20 inc vat
In stockRecommended usage 1 x 14A8347 to fit one mini.
For Minis with sliding windows and external door hinges These genuine L/H outer A panels fit over the extra inner panel which have brackets on to reinforce the exterior hinges. If the outside one is rotten you can guarantee the i...
For Minis with sliding windows and external door hinges These NON genuine L/H outer A panels fit over the extra inner panel which have brackets on to reinforce the exterior hinges. If the outside one is rotten you can guarantee t...
For Minis with sliding windows and external door hinges These genuine R/H outer A panels fit over the extra inner panel which have brackets on to reinforce the exterior hinges. If the outside one is rotten you can guarantee the i...
For minis with sliding windows and external door hinges.
This is the inner hinge panel with the brackets on to reinforce the areas where the hinges sit. You will require the outer panel also 14A6901 for R/H and 14A6902<...
Genuine door hinge panel L/H for all MK3 Minis with internal hinges and doors that have wind up windows. Although it is a single wall panel it still has a tendency to develop rust spots so the trade prefer the best fitting thicker upgraded [link]ALA5...
Genuine door hinge panel R/H for all Minis with internal hinges and doors that have wind up windows. Although it is a single wall panel it still has a tendency to develop rust spots but a slightly thicker upgraded panel the local bodyshops love is [l...
For Minis with sliding windows and external door hinges These genuine L/H outer A panels fit over the extra inner panel which have brackets on to reinforce the exterior hinges. If the outside one is rotten you can guarantee the i...
MK1/2 toe board with steering rack mounts.
Crossmember to inner wing bracket bracket for Mk1/2 L/H
not mini clubman
Crossmember to inner wing bracket bracket for Mk1/2 R/H
not mini clubman
Rear subframe mounting stiffener L/H repair bracket with holes for subframe mounting and attaches to wheel arch Fits on ALA8623
Floor pan for Mini van/estate with no x member for remote change gearbox. Non Genuine. For saloon see 14A6491
picture is just to show what you get but bulge on centre tunnel for starter button appears to be on wrong side as this...
Van roof panel for post 1966 cars, these are without vent piercing.
Non genuine but the only panel available.
Metal floor plug as per original with rubber seal.
For use in 1" hole.
Non Genuine L/H lamp repair panel for rear corner panel on the Mini Pick-Up.
The top rear capping panel is also available as 14A7558CAP
Non Genuine for the Pick-up and Van 1961-64 with a slat type fixed grille as a trademark for Mini commercial type vehicles originality.
Usually ordered for customers requirements as these are very rare models.
This panel has no b...
Non Genuine R/H lamp repair panel for rear corner panel on the Mini Pick-Up.
The top rear capping panel is also available as 14A7557CAP
Although this panel is non genuine it is the most accurate for MK1 Cooper S restorations as it has the correct number plate brackets and slam panel.
If you have a pre 1964 car with the one piece valance with no cooling cut outs for brakes ...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.