RH FLOOR TO SILL REINFORCEMENT SLINGER BRACKET
14A9552

($9.00) £9.00 exc vat

($10.80) £10.80 inc vat

In stockIn stock
Small reinforcement bracket panel between the inner and outer sill on the RH side rear. The 24A42 slinger sits underneath this bracket under the sill panel.

($9.00) £9.00 exc vat

($10.80) £10.80 inc vat

In stockIn stock

Recommended usage 1 x 14A9552 to fit one mini.
Saloon Floor Panels - Qty 1

Recommended products

These 4" wide sills are genuine Rover replacement parts with 6 vents and are for MK3 on saloon. Non Genuine is MS63R

Most/many 1970 cars and Cooper S mk3 had 4 flutes.

They will fit MK1/2 but not original fitment. Clos...

Every mini saloon has these,2 of 24A41 on either side front and 24A42 /24A43 sided on the rear --only purpose was for building/moving/ storing and preparation of cars at the factory to sit them on ..Also acted as a stiffener...

People also bought products

Genuine R/H rear quarter outer skin from the B post back for MK1/2 cars with sliding windows.

Rear subframe mounting stiffener L/H repair bracket with holes for subframe mounting and attaches to wheel arch Fits on ALA8623

Rear subframe mounting stiffener panel R/H with holes for subframe mounting to wheel arch. Sits on ALA5524 or ALA5528

Metal floor plug as per original with rubber seal.



For use in 1" hole.

Although this panel is non genuine it is the most accurate for MK1 Cooper S restorations as it has the correct number plate brackets and slam panel.

If you have a pre 1964 car with the one piece valance with no cooling cut outs for brakes ...

Non genuine rear companion bin for external hinge cars. These are supplied without the ash try mount.

Non genuine rear companion bin for external hinge cars. These are supplied without the ash try mount.

Body side rear lower w/arch to rear section of bodyside repair L/H. 220mm tall.

Repair section of bottom of door for external hinge cars, MK1/2.

This crude non genuine parts is the only repair section available for early doors apart from door skins.Lots of stretch marks and wrinkles but they have been fitted by customer...

Repair section of bottom of R/H door for external hinge cars, MK1/2.

this crude non genuine parts is the only repair section available for early doors apart from door skins. Lots of stretch marks and wrinkles but they have been fitted by cus...

non genuine L/H outer MK3 door skin lower few inches repair section.

not as good a fit or looking as the genuine complete skinCZH3301

Non genuine L/H saloon inner sill. Only made as an after market replacement as no genuine part was ever available seperately. Best one on the market for a comlplete inner sill replacement panel. With carpet fix brackets.

Non genuine R/H saloon inner sill. Only made as an after market replacement as no genuine part was ever available seperately. Best one on the market for a complete inner sill replacement panel. With carpet fix brackets.

Non genuine section repair panels equivalent to MS51VAN. This is the left hand side with castellated nut fittings for subframe

For vans with metal load floors and pickups so match up before cutting out to much material

Non genuine section repair panels equivalent to MS51VAN. This is the right hand side with castellated nut fittings for subframe

For vans with metal load floors and pickups so match up before cutting out to much material

part inner wing L/H from Damper bracket mounting pointing forward for SPI modles 1991-96 with large round electric radiatore fan hole

NON genuine panel

part inner wing R/H from Damper bracket mounting points forward MK1 except Clubman. 1959-69 it has no air hole in side-see CZH3064 for later type with hose hole.

NON genuine panel