A very usefull tuning needle for single and twin carbs when camshaft change for carbs with floating needles.

Probably the most changed stud on the mini. This is the length used on every A series engine until the introduction of the sandwich plate when longer ones were required. A stainless steel variety C-STR286 is available which we do recomme...

These spherical rod ends are also known as a Rose joint which is a registered trade mark. We use these ends on some of our weber carb linkage kits and anti roll bars. This is the male type threaded joint.

This fitting kit suits all later day 1.25" and 1.5" twin carb set ups where the balance rods between the carbs required are equal length (2.25"), some early carbs had the balance bar with a triangular plate that were a shorter length. The kit has the...

Minispares UK manufactured seal for the non locking standard petrol caps it is now made of a petrol resistant material that will fit any genuine petrol cap.

It has a 60mm outer diameter and a 39mm internal diameter hole which is close enough...