MK1 SWITCH PANEL CONVERSION PLATE
MS029

($9.00) £9.00 exc vat

($10.80) £10.80 inc vat

In stockIn stock
This is small plate that welds into the later lower dash rails to convert them to mk1 size for people who want early switches in a late car.

($9.00) £9.00 exc vat

($10.80) £10.80 inc vat

In stockIn stock

Recommended usage 1 x MS029 to fit one mini.

People also bought products

Crossmember at the back of the engine bay where the master cylinders fit, fits MK1/2 models.



correct shape for a mark one unlike the laster version that is modified for carb clearance

MK1 front bulkhead skin to suit mk1 with the round hole for the heater trunk pipe. Bonnet hinge brackets not fitted.



Can be used in later models with some adaption.

Crossmember to inner wing bracket bracket for Mk1/2 L/H

not mini clubman

Crossmember to inner wing bracket bracket for Mk1/2 R/H

not mini clubman

Rear subframe mounting stiffener L/H repair bracket with holes for subframe mounting and attaches to wheel arch Fits on ALA8623

Rear subframe mounting stiffener panel R/H with holes for subframe mounting to wheel arch. Sits on ALA5524 or ALA5528

Metal floor plug as per original with rubber seal.



For use in 1" hole.

Non genuine rear companion bin for external hinge cars. These are supplied without the ash try mount.

Non genuine rear companion bin for external hinge cars. These are supplied without the ash try mount.

Body side rear lower w/arch to rear section of bodyside repair L/H. 220mm tall.

Repair section of bottom of door for external hinge cars, MK1/2.

This crude non genuine parts is the only repair section available for early doors apart from door skins.Lots of stretch marks and wrinkles but they have been fitted by customer...

Repair section of bottom of R/H door for external hinge cars, MK1/2.

this crude non genuine parts is the only repair section available for early doors apart from door skins. Lots of stretch marks and wrinkles but they have been fitted by cus...

part inner wing R/H from Damper bracket mounting points forward MK1 except Clubman. 1959-69 it has no air hole in side-see CZH3064 for later type with hose hole.

NON genuine panel

Non genuine repair panel for below the lights and above the rear valance, fits all models. Right hand side.

Non genuine repair panel for below the lights and above the rear valance, fits all models. Left hand side.

Small bracket under the front bumper lip to hold the number plate, sold singly.

Non genuine rear valance closing panel with subframe mount repair



The rear valance of the Mini is a panel that is very often in need of replacing. While rear end damage can be a good reason, the most often cause is rust. The pane...