£41.00 exc vat
£49.20 inc vat
In stock
£41.00 exc vat
£49.20 inc vat
In stockRecommended usage 1 x AUE1111 to fit one mini.
This is the original type of needle valve that governs the plastic fuel float in your SU carb.
An alternative better upgraded version is available as CA90.
Gasket for an HS4-carb and manifold .Sold seperately and order as required for your car(usually 3).
This is the original type of needle valve that governs the plastic fuel float in your SU carb.
An alternative better upgraded version is available as CA90.
Our heavy duty throttle cable is superior in many ways.
A nylon interior ensures smooth operation. The outer cable is 32mm longer and inner is 95mm longer than the standard one.
Cable to carb bolt is ACC5062.
The favourite and best needle for Minispares stage one kit. Tested on a rolling road by Peter Baldwin this baby gave the best performance when using our RC40 system, Minispares inlet and exhaust manifold plus a K&N filter.
If us...
Pin to hold the accelerator cable which locates in the carb bracket lever. Supplied as originally fitted with washers, nut and split pin plus a proper machined hole for the cable unlike many others on the market- which come either bare or with wrong ...
Worn throttle spindles cause erratic performance from your carb and sometimes the housing gets worn--These are the bushes to repair worn carbs when replacing spindles for HS4 carbs. As a guideline 0.3125" internal diameter ream body to 9...
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps.
If you need the 5/16...
If fuel is overflowing the float bowl the needle valve is leaking. This may be caused by the float WZX13040(GSU200) being misadjusted, stuck or leaking OR the needle may be fouled with a bit of grit or worn and not sealing. This is an
altern...
Vent pipe from petrol tank
late cars were only 765mm or 31" approx, but Mk1 cars were 54"
Saloon petrol tank retainer clip for the rubber seal on the sender unit which is ARA1502 .Early tanks had 6 screws holding the sender unit in place and used gasket GUG705711GM
Worthwhile fitment on any car and a must for performance engines. This filter has 1/4" ends for standard use, for 5/16" larger bore see PRO805. Supplied as per picture.
Stainless steel polished locking cap for all post 1970 cars-non vented.
Comes with 2 keys.
Not for injection type cars.The original shape/type chrome cap used on the mini, this is vented and non locking. Originals were non vented on saloon and vented on Van/Estate. Quantity required is one unless you have a saloon with twin tanks (2 requir...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.