£12.50 exc vat
£15.00 inc vat
In stock
£12.50 exc vat
£15.00 inc vat
In stockRecommended usage 1 x PRO805 to fit one mini.
5/16" UNF THREAD 2 1/2" LONG bolt commonly used for 21A2838 petrol tank strap
7.5 gallon tank has both pump and sender unit holes for injection cars only. Some people use this tank for turbo applications however.
Non-genuine version of the choke cable fitted to the early minis which does
not lock into place like the twin carb version. (see 21A1204).
It was made to work with the single HS2 carb and had only the word "CH...
Genuine Mini Spares product. The seal that goes on the neck of petrol tanks as protection against water intrusion and to also to make the hole look neater, so replace them when they crack or shrink through heat. This is the original fatter type as us...
Original 7/16" spring type hose clip as used on later cars (approx 1990 on) for some radiator hoses and fuel lines.
The main cause of failure is water in the pump. This is caused by modern ethanol fuels. Be sure to clean the tank out before fitting and drive your mini more to avoid water build up.
Replacement pump only for the original WFX100810<...
5/16" bore petrol hose for injection cars sold in metre lengths.
Resilient to heat,weather and suitable for ethanol in modern day fuels.100psi max.R9 spec.
5.5 gallon left hand tank with twist in sender unit.
For all mini saloons from 1964 until 1980 except Elf and Hornet. Also except the 1275GT from 1974 which used the later 7.5 gallon tank which became standard fitment to all mini saloons fro...
Used on Facet range of solid state and silver fuel pumps SS501/2/3 with 1/8" nptf thread size with 1/4" standard fuel line.
Small hose clip for 1/4" fuel line (our part number PETROLPIPE)
Mini Spares Non Genuine version mechanical fuel pump. Brilliant aftermarket alternative for cars pre 1990.
Drives off the camshaft at the rear of the motor. These pumps are generally reliable but when a diaphragm goes bad it can be very bad ...
This is the small plastic nut used to hold the fuel line protector shield on later cars, also used to hold the catalytic converter heat shield on, 4 required for each shield.
Non Genuine metal bodied electric fuel pump with metal banjo pipe ends for long life,with blue plastic end. Ethanol tolerant and resistant internals.
This is a cheaper alternatives for the original SU pumps, different to look at and fit but ...
THE ELECTRICAL CIRCUIT FOR THE FUEL PUMP INCORPERATES AN INERTIA FUEL SHUT OFF(ifs) SWITH WHICH WILL STOP FUEL BEING DELIVERED TO THE ENGINE IN THE EVENT OF SUDDEN DECELERATION--It is fitted in the engine compartment, fixed to the bonnet switch brack...
For 1275cc engines after 1990 on with HIF38 carbs.
has a 5/16" (8mm)inlet which makes it unique to this model
The 1990-1 models of the Mini with 1275cc engines and HIF44 carbs use a AZX1817 mechanical fuel pump. Driven ...
Gasket/seal for mounting the fuel pump to tank for SPI and MPI Mini's
Seal to fit between union WKB10019 and the fuel filter on injection cars.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.