The front bumper of your Mini should be mounted to this simple 'L' bracket that should in turn be spot welded to the lower edge of your front panel. Often damaged in accidents with the bumper. If you replace the entire front panel of the Mini it incl...

Boot hinge gaskets and fittings for original type hinges

High quality non genuine door check strap for MK3 cars with wind up window doors (use with retaining pin CLZ412). Beware there are cheap copies on the market that are poor quality and when fitted to our cars did not function correctly!

This is small plate that welds into the later lower dash rails to convert them to mk1 size for people who want early switches in a late car.

MK3 Door & boot handle fitting kit, including original type screws, star washers and gaskets.

Non genuine rear companion bin for external hinge cars. These are supplied without the ash try mount.

Complete set of bolts to mount the front subframe on all post 76 single bolt subframes less the large tower bolts and towing eye, enough fixings are supplied for those who wish not to use a towing eye.

Tank strap bracket welded to the rear of the boot floor which the single diagonal tank strap 21A2838 attaches to.

Van R/H full length half floor. You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width and length -plain pressed floor with indents but no carpet brackets or lugs underneath.

Body side rear lower w/arch to rear section of bodyside repair R/H. 220mm tall.

non genuine R/H outer MK3 door skin lower few inches repair section.

not as good a fit or looking as the genuine complete skin CZH3301