£64.20 exc vat
£77.04 inc vat
In stock
Originally sprite and mini straight cut gears were the sam but with modern technology it was found smal...
£64.20 exc vat
£77.04 inc vat
In stockRecommended usage 1 x C-22G1050SPRITE to fit one mini.
Budget priced baulk (synchro) ring has been the same since 1962, originally steel but then sintered. These rings slow down the gears to insure that they mesh without crashing. They have a machine surface on them that is the first thing to engage the ...
Genunine Rover sintered baulk ring. Use our 22G2033EVO sintered baulk ring, which is the best quality standard baulk ring currently in the market place and as used in our 5 speed gearboxes.
Our 22G2033MS are also si...
Mini Spares Performance Baulk ring.
The standard sintered baulk (synchro) rings are not tough enough for the demands of performance useage, in many instances lasting only one race before failure or breakage. The main reason is the incompat...
Straight cut gear set as designed by Special Tuning which contains only the -laygear,1st Motion shaft,2nd and 3rd gears. Not only does the straight cut design provide more strength and take significantly less power to drive but the ratios of the var...
Straight cut laygear for SC/CR 3-sync gearbox.teeth count 13-17-20-23
Made especially for the Spridgets to overcome junmping out of gear where hubs or selectors are worn, this is the same original ST ratio but with slightly different dog teeth design. Same for 2nd and 3rd.
Straight cut gear set as designed by Special Tuning which contains only the -laygear,1st Motion shaft,2nd and 3rd gears. Not only does the straight cut design provide more strength and take significantly less power to drive but the ratios of the var...
If you are using a straight cut close ratio gearbox this could be a great spare to keep. The biggest problem with this box is typically not even seen: the bearing surface for the pilot bearing that fits into this 1st motion shaft can lose its hardnes...
If your gearshift lever transmits a lot of rattle and noise, replacing these three tiny but significant parts will likely cure it. The kit for the Spridget or Minor consists of the brass plunger (22A84) and spring (AEG3123) plus the nylo...
This little roller bearing goes inside the end of the 1st motion shaft on minis with 14mm mainshaft which it sits on.
This bearing was previously part number 88G409 and a true Rover replacement, but if you have earlier A type gears with the...
Mini Spares Performance Baulk ring.
The standard sintered baulk (synchro) rings are not tough enough for the demands of performance useage, in many instances lasting only one race before failure or breakage. The main reason is the incompat...
When in doubt replace it. You have heard this many times but you better believe it on this part. If you have not personally just replaced these layshaft bearing then do it now while you have the chance. These bearing will destroy the inside of a very...
This kit consists of one alloy sleeve with a groove on the outside to locate the O ring, the new "O" ring, a rod seal and a gaiter. To fit the kit simply remove the old gaiter if fitted and then the old oil seal. Fit the sleeve with the "O" ring fitt...
32 tooth first gear outer track only, for the sprite/midget 3 synchro gearbox.
This part number was for complete 1st gear hub assembly originally and the outer track was 22G1119 but when Rover stopped production we used this same number for<...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.