£232.45 exc vat
£278.94 inc vat
Special order
These fit correctly and snugly in your car over the tunnels etc for that professional look. 2 rubber front foot pads and on rear carpet has r...
£232.45 exc vat
£278.94 inc vat
Special orderRecommended usage 1 x CK962PB to fit one mini.
Moulded red carpet set for Rod change change with soundproofing attached where appropiate.
These fit correctly and snugly in your car over the tunnels etc for that professional look. 2 rubber front foot pads and on rear carpet has reinforcem...
Moulded blue carpet set for Rod change change with soundproofing attached where appropiate.
These fit correctly and snugly in your car over the tunnels etc for that professional look. 2 rubber front foot pads and on rear carpet has reinforce...
Make it like a Rolls Royce! The Mini will never be as quiet as a Rolls but every bit helps. If you have a carpet kit without this insulation you are missing a great opportunity for increased comfort. The kit includes a tailored floor set,front wheel ...
Our own tailored over-mat set for front and rear with the union jack emblem that used to be our trade mark before we changed to the love heart mini logo.
These panels hold the door panels in place under tension inside the door aperture. It is not essential, but well worth replacing or renewing these in conjunction with new door panels. Sold in pairs.
Black door pocket liner for the R/H door which has sliding windows and external hinges
Black door pocket liner for the L/H door which has sliding windows and external hinges
In 1993 the seat frames were changed and although the base frame looks very similar to earleir models, there is a difference in the shape. At this time the seat diaphragm was changed to a special rubber/woven design known as the "Suisiara" model. The...
MK1/2 interior door handle with screw and washer.
This solid "spoon" handle is brittle and easily broken.
These are the original shape as sold under the Unipart label, not the later Rover bagged item which was a reproduction with d...
Rear Alloy Brightwork moulding for the interior rear companion box R/H.
deleted for EMB10013 plastic in 1991
The special pointed shape buffer locates against the boot board of Cooper S and variants where a factory type boot board is fitted.
Vinyl covered 9 piece black interior trim kit
This kit is for wind up window type doors,for MK3 saloons 1973 onwards (except Cooper S) and contains 2 door trims,2 rear quarter trims,rear parcel shelf,2 rear glove box trims and 2 rear wheel a...
Favourite old ashtray for MK1/2 minis with the fluted top for the rear glovebox and facia. Fitted to minis with painted top dash rail from 1959-85.
See 24A1538 also for flat lid version as fitted when top dash rail is vinyl cove...
Lower moulding clip for wind up window mouldings..4 PER SIDE required but sold singly-Fits CZH1666/7 and PAM1014/5
Also used for 24A1169 glove box moulding MK1/2.
Seal for door handles MK1/2 and all sliding window exterior hinge cars.
also used on 14A7195 mk1 boot handlle used on mk1/mk2 and van/estate
is oval shaped
for boot / rear door use the hole at the rear ...
This plastic clip was commonly used by Rover for all car trimming and first found its way on the wind up window version mini door panel.9 per side but always purchase a spare in case of breakages.
The lower brightwork moulding for finishing off the lower dash, crash pad rail or on earlier cars the painted metal surface of the panel which holds the switch panel section.See 14A8010 for clip
This moulding was fitted to all m...
Fitted for safety regulations to all MK2 minis from 1967-80 except Sweden and Canada to 1975 (not any MKI or van and pick up). Later commercial type minis did have it fitted with 3 clock speedo pod. This is a hard foam pad at the lower edge of the pa...
Rear Alloy Brightwork moulding for the interior rear companion box L/H.
from 1991 the metal type were replaced by EMB10013
This is Rovers tailor made plastic boot liner which fits all cars with the larger 7.5 gallon petrol tank fitted from about 1974 on. Fits over the spare
wheel giving a very sturdy load floor with a recess for polish or small tools etc. If thi...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.